开云体育

Hello! Yes, it HAS to do with Tektronix... just read ;-) I have just returned from a trip to the 'Cote d'Azur' (Blue Coast) in France (I am from Spain and it is about 850km from my home). I have

Trouble is, isn't the 400E the little solid-state meter while Don's link is for the 400D/H, the VTVM? Dean

Steve, the T935 is the delayed-sweep version of the T932. The T912/T921/T922 was plagued with a problem with the female connector on the main board that connects to the power supply. It was always

the 2200 series is notorious for leads popping off the neck of the CRT (deflection plates) when the bottom board is flexed, the unit is shipped or when somebody works on the scope. the symptom is

Good work Don. Thanks Phil

Oops! The link to the test equipment site is <http://www.one-electron.com/FC_TestEquipment.html> . Just as well the old head's screwed on tightly, I'd forget that too. Don Black. "Phil (VA3UX)"

Hi Everyone, Here's a link site for test equipment schematics and manuals. I've posted it here as I think it's worth everyone bookmarking it for future use. It has the HP400

I don't know if this will translate to your situation, but my eBay 465 did the same thing (first vert then horiz and then I had to fix it) and I found overheated and open resistors in both vert and

Please read below folks. Can anyone help out Will with a schematic ? Please reply directly to him. Sorry Will but I don't have a schematic for the 400E. Phil

Hello all, I have a DP501 prescaler, plus a TR503 tracking generator for use with a 496 spectrum analyzer. I understand that a DC503A is one counter that will hook up to a DP501, and with logic

I have a tek 2215 on which both traces will not go lower than about 1/3 rd from the top of the screen. any help is appreciated WDJ

Stan, I have bought from you on eBay a couple of times. Sorry I can't help with the 3A2 / 3B2. I am also looking for some 56x series plug-ins: 3A8 3A9 3S1 3S7 / 3T7 (ideally the pair with GR

Phil, I am looking for 56x series plugins, specifically the following: 3B3 3A8 3A9 3S1 3S7 / 3T7 (work only as a pair, require a short GR cable between them) 3L5 with or without the companion

Could I hear more about the "spot-o-gold" problem? I have 7K plugins...

Greetings; what My 212 is the most exasperating Tek item I own. I no longer have any expectation of it working properly. My T932 has had to go back to the 'scope doc twice for P/S probs (Wasn't

A variety of solutions for this, including larger heatsink as Walter stated. Gee. I though the thumb rule was supply voltage 80% of cap voltage rating? . > the 1X / 10X panel A solution, which I

Hi Dean, It seems to load OK for me . . . Maybe it was down for maintenance for awhile. Stan dhuster@... wrote:

Hi Phil, I still need a 3A2 and a 3B2 if you can find those . . . Stan Phil (VA3UX) wrote:

Walter, I have made that comment before to folks. It is true that for the most part, it get depressing working in a service center, because after you finally get a scope repaired and calibrated,

I'll start a new thread since the 465M thing is getting a little diluted with everything else ... I certainly haven't helped! Yes, the 434 X1/X10 lamps were the worst, requiring complete removal of