开云体育

I'm looking for a new toy and am thinking about a 7904 or R7903. There is a lot of material in the archives but I would still like to get some ideas from the group as if this is a good choice or if

- Before tearing into everything, I would start out by putting the scope into X / Y mode, ( make certain that the intensity is turned down), and checking that the spot can be positioned all over the

weinerhi wrote:

Howdy- Does anyone have a spare CRT bezel that fits on the TEK 310 - 316 - 317 - 360 'scopes? I believe the above four TEK scopes all use the same CRT bezel. The "3" series all use a 3" CRT. Any help

There are lens polishing kits in automotive stores for headlines lens. If the plastic is compatible, it might work ? Bob

Hi all, I picked up two 7S12 TDR plugins for my Tek 7854 scope on eBay. I checked them both out and they're fine. I only need one and would like to trade the other for any of the following plugins

HELP!! The sliding plastic dust cover on the rear of the Tek 496P was difficult to slide, so I sprayed some silicone spray to lubricate it. While the spray freed up the cover, I noticed that it had

I might me getting a DM44 soon, not sure what parts it will come with other than the DM44 itself...if I get a hold of it, would anyone be interested in it? ~Jordan~

<go_boating_fast@...> wrote: I totally agree. Several functions were not working on my scope. I found a bad electrolytic in the power supply, tacked in a replacement, and most of the functions

Hi, Does anuone know of a T912 operators and/or service manual available to download please? I've misplaced my manual and need to check something until I find it again. Thanks, Don Black.

The group can reply if they disagree, but I would start with the power supply. Make sure all voltages and ripple are within spec. Everything else depends on the power supply working correctly. If you

Dave_s wrote: Here's one: http://www.qsl.net/iz7ath/web/02_brew/15_lab/06_esr/ Ed

There have been a few requests here for Tek ceramic solder strips, and I got one big batch of 7 slot parts (124-0158-00)), brand new in factory bags. There are pics and more data here at the start or

Or FleeBay it and get a TR503 in a tm502 or 503 PS. Mitch N4MF No my TR-503 ain't for sale, being used with the 2794. ______________________________________________ patient tracking

Hello to everyone. I'm a new member needing some advice on where to start with a 475 o'scope that doesn't display a trace signal and when I use the beam finder I can locate a stationary dot for both

About all you can do with a sweep generator is use MAX HOLD, and be patient while the trace points all fill in. -- john, KE5FX

They are not really compatible, since there's no way to synchronize the Wavetek's sweep to the spectrum analyzer's. The Wavetek is intended to be used with a broadband detector such as an HP 8471

I think the Tunnel Diodes (typically used in the trigger circuit) would be worth keeping. They seem to have a finite lifetime and can be difficult to find. Regards, Len much in the years ago parts

Hi, Any suggestions for using a Wavetek 2002B sweep generator as a tracking generator with the 496P? Thanks.

---- Dave_s <group78@...> wrote: Very sorry, try this http://ludens.cl/Electron/esr/esr.html