开云体育

I am looking for a ops manual for the Tek 2465 that includes options 9 (char recognition) & 10 (GPIB). I have the standard 2465 ops manual. The Bama site does not have anything on the options. Thanks

Hello, Are these two power supplies interchangeable? If not, does any know if they can be or what the differences are. Thank you, Bernice

Thanks for taking the time to post the guide. I have saved it in case my 465B finally dies. Phil q2SdbUfkdcsrK5gN4e18raEsU50nNi4FCLjYcnItRxxs2rveWeKfOOm3nGbbGE0xevMPev-

Any ex-Cylink or Pcom folks out there? -Dave

My Tek 465 Z-axis problem is finally fixed, too. A command decision was made to change out all of the power supply electolytics. The trials and tribulations of this project were documented, warts and

Hello, This email message is a notification to let you know that a file has been uploaded to the Files area of the TekScopes group. File : /Tek 465 Power Supply Capacitor Replacement Guide.pdf

Take a look at the left side of the plug-in. There are two option jumper plugs you need to be concerned with, located on the sweep logic board near the backside of the frame. The first is the

TDS784D. full few replacement? 1) Downloadable from Tek's web site 2) Yes 3) This is not a conventional LCD display. It's a monochrome CRT with color shutter. There is at least one company selling a

I am trying to use a 7B92 timebase plugin in my 7704. Everything seems to work well except I cannot get any "delaying" and "delayed" trace separation. Both traces are visible sitting on top of one

Hi; I am new to the group and am looking for some info to help with my TDS784D. The problem is that the internal display is very very dim even at full intensity. Everything is fine on an external

Thanks for your reply David. According to another reply I got in the HP group, I needed to have the internal calibrator output connected to analyzer input. Perhaps this was too obvious for me? In any

Hello, "Winning with People: The First 40 Years of Tektronix by Marshall M. Lee" Does anyone have a copy of this book for sale or know of where I can get one? Thank you, Bernice

These use the internal 100 MHz at -30 db calibrator to check for sensitivity, gain calibration, log tracking (by switching the main atten in and out)... as far as I know the fail is not latching, but

Sorry if I offend anyone by asking in Tekscopes about these fine Aeroflex/IFR instruments, but there are so many knowledgeable folks that hang out here! I'm trying to figure out what the "CAL" self

A long time ago, I used Tektronix's ForTran plotting software, first with a 4010, then with a VT-100 retrofit to support the Tektronix graphics commands. Years later, I found out that Tektronix had

This unit looks very beat up to me. And Tampa is on the ocean, the salt air might have got to it.Might be worth a try if you did not have to pay shipping, but you can probably do much better for under

Is anyone here bidding on this, and if not, do you think its worth pursuing? Item number 270282625252

I bought a load of these on ebay and some 7623/33/03's, 18 in all from a local university for the same price. It was within driving distance though. I would shop around some more.

Thanks everyone. My 535A has started misbehaving again and I was wondering if that could be the reason. Maybe it's an intermittent contact in the 1A1 edge connector. I'll have to investigate... --

Yes, the fan suck dust and fluff from the floor necessitating frequent cleaning of the filter - otherwise no problems that I am aware of. Geoff -- Geoff Blake G8GNZ located near Chelmsford, Essex,