开云体育

Problem with spamhaus is it would appear that it only takes one email to them saying a domain is a spam source and they block it without investigation. ? D.

Groups IO sent me a message the other day complaining that my mailer was bouncing messages and they were suspending email until I unbounced it. Turned out my mailer was bouncing their mail because

I think you need to first create a new album and upload the photos separately. Then put a URL link to the photos or album in your message.

One important thing to remember is that CB channels below 24 are NEITHER contiguous nor numerically ordered. So to repurpose these switches, you might set up an LED matrix to show continuity per

To All - I did not post that link.? Dont know where that came from.? i have not posted anythin to this list for a few months. 73, Bill WA2DVU

I had to install the position potentiometer - it is missing - and therefore it must be the "upper and lower sreen switch" removed. No idea, how the removement works? No scew, nothing? I need your

I bet this scope was originally being used at 120V mains, and the protection was barely being able to cope with the fault. But once put on Euro 240V it definitively was too much for the PS.

It looks like this encoder is arranged in 4 decks. My approach would be to look for a unique pin on each deck which is switched to more than one other pin as the shaft is rotated. This should be easy

You're right, trying to work it out with an Ohm-meter will take forever and possibly cause brain damage. So it sounds like a job for an Arduino (Nano). It can scan all the possible connections quickly

Hi, Interesting, that is definitely not going to work in a lot of places outside the US. At least here, for example (Hungary, but I think true for most of Europe) it is virtually impossible to pull

Ed Breya <edbreya@...> added the album 40 position encoder switch: Accord PSS-23 switch --- The following photos have been uploaded to the 40 position encoder switch (

That link may not show properly. I have put a picture in the photos department, just in case. Ed

I have a few old 40-position absolute encoder switches that probably came from some 40-channel CBs I junked out years ago. One of my projects is a special time mark/clock/risetime-check generator type

Hi Bill, If you are going to post a suspicious link please be sure to say what it is for. I can confirm (for Bill) that it is not suspicious after I checked it out. It is a box of CRTs in the Portland

Someone stated: … "it's very important IMO that you use a *top* quality solder such as Kester even when unsoldering a joint. The Kester 2% silver loaded solder is hard to find and is now stupidly

Thank you Alastair for pointing out an extremely important point about all of these financial discussions whether it is with eBay, PayPal, Credit Cards, Banks (Federal or State), or Credit Unions: The

Added some more photos /g/TekScopes/album?id=263432

Sorry it took so long to reply, Bert.. My curve tracer went wonky and it took days to figure it out. It turned out to be the Power Cord where it enters the cabinet. Intermittent operation but never

There may also be a difference in the transaction fees that eBay needs to pay, as in one may be a flat fee while the other may be a percent of transacted amount. It's been a long time since I looked

One thing to note is that credit cards may be easily disputed, thus not guaranteeing EBAY their money immediately.? Bank accounts may be harder to dispute and more difficult to correct. Note: in the