开云体育

The Often the Tantals for Supply Decoupling having a short. The Chokes which are lo

Good Evening I have a 7704A mainframe that is in need of repair. I turned it on this morning after not having been powered up for about 2 years. The trace was moving around erratically. Then I

Bill, if you don't mind knobs that aren't perfect, I have enough used ones to set up. They may be cracked, have a soldering iron ding, have some paint rubbed off, but they're serviceable. When I

Hello, Would anyone have a vertical output hybrid for a 7844? Tek part 155-0064 I believe... If anyone has a 7844, I can email them the necessary pictorial info where the part is and how to remove it

This allows as Interesting... thanks! So it's the 2/3 series equivalent of the type Q strain gauge then, I assume. George

Hello, if anyone has access to or knows a source for the following 466 parts, I would be grateful: - (2) A&B trigger level knobs #366-1280-00 - (1) B trigger slope knob #366-1278-00 - (1) vertical

What's REALLY bad about leaving the filter out of the 465/475 scopes is when they're used "IBM" style -- rear on the floor while working on equipment. That fan "vacuums" up every dust moozie in

the is (and Hello Dean, I remember the Filter-Kote (milky water-soluble oil?) days for the metal filters in the 5xx scopes (!) I've been cutting up the

Hi George, The 3C66 interfaces to a wide variety of mechanical transducers. This allows display of all kinds of mechanical measurements on the CRT face such as vibration, mechanical shock, shaft

What does a 3C66 carrier amplifier do, or what do you use it for? Thanks! George

manual That can be some handy information. But be forewarned about U.S. Army calibration T.O.s (Technical Orders) which the USAF also uses. I have seen some that leave a lot to be desired. For

I'm not sure how helpful this is, but the government calibration manual for the TU-7 / 1M1 / 067-0521-00 / 067-0521-01 is available online: https://www.logsa.army.mil/etms/data/A/009074.pdf

Hi George, I think you can get by just fine with the 067-0521-00 manual for maintaining your 067-0521-01. Those units require almost zero maintenance anyway. You will probably never have occasion

545A. later. I have a 067-0521-01, how much different is this and would a 067-0521-00 manual be sufficient for maintenance and usage of this unit? Thanks!

Hi Marc, Yes, the 1M1 is a very good tool to use in adjusting and checking a 545A. the 1M1 was also known as the TU-7 earlier and then the 067-0521-00 later. It is a newer instrument than the 545A

Sure. This plugin is also known as the 067-0521-00. Manuals are available from: Bob Howard howardr@... http://www.magma.ca/~howardr/manuals.htm Ron Ford W.J. Ford Surplus

Two-part query: Would a 1M1 Test Unit plug-in be a useful tool in checking and setting up out a long-disused 545A scope? I have the plug-in but am not sure of its intended application. Does anyone

Hi, Don, The grounding spring you need was used in about 30 different models of Tek scopes, so if you find a complete junker anywhere, you may also find the part. The pouch lip can be a problem.

Ashton Brown wrote:

Hi Don, The Service Manual for the TAS465 is part number 070-8524-01. I have a copy of one in my workshop (not for sale). The only problem being is that I live in Sydney, Australia. Best