开云体育

Ditto. I found a TU-7 on ebay for a reasonable price on ebay awhile back after searching for several years. DaveD KC0WJN [email protected]> wrote:

The130 uses two low frequency oscillators, 100..150 kHz. No modern line filter works below the FCC, or other minimum frequency. The instrument is not affected by incoming EMI nor creates conducted

Just keep an eye out on eBay for them, I bought a 1M1 for $40 plus shipping and a 067-0521-01 for $120 with free shipping a few months ago. They do come up cheap every now and again.

As my Tek 130 has lost its NEMA 5-15 inlet, and been butchered to use an IEC inlet. I'm tidying up the rear panel and adding a small anodised plate to cover theunsightly square-peg-in-round-hole

Hi Everyone, Happy new year. I have built a PC based calibration and verification system, early days. I am looking for info, s/w on Lotus measure, potentially one key element

I would think that very possible. HP developed a three-piece VTVM calibration system for use in the factory and by field techs. The calibration generator was originally assigned a five digit

I have not seen the history of these fixtures, the TU-7, 1M1, and 067-0521-01. I would like to believe the products developed out of in-house test fixtures used to initially calibrate new units, or in

Wow! Three hundred bucks plus shipping. I have noticed a substantial increase in price for 500 series on eBay, but didn’t know how much. Good luck in your search.

Does anyone have a 067-0521-01 that they don't need anymore? I see a couple on the famous auction site but the prices seem excessive. (even compared to recent historical pricing)

Hi, why not check feedback resistor R1589 47ohm and also R1571 10k, C1571 100p. G?ran

I started looking at the vertical interface board and how the 7A18s could not work here while 7A26s are fine, then took some wild goose chases that were dead ends. I decided to make sure it was the

I'd like to have some of those boards. I have two 7A13s and would like to replace all the relays. I also have a 7A12 which uses 8 of them. In addition I need two of the "polarized" relays

They operate a test equipment calibration service and sales from a brick and mortar so it's a step up from an ebay seller but yes that price is still absurd for what it is. What drives me nuts is that

I'm certainly interested, at least in the PCB. I've actually been having this same battle with a 7A13 this last week, and was getting read to ask the list if anyone had published a PCB adapter since

Typical eBay seller. A $13,000 device, $1000 for shipping , one picture and description copied from the brochure. Anybody who would spend that kind of money based on the listing gets what they

The following photos have been uploaded to the Tek 148-003x-00 relay replacement ( /g/TekScopes/album?id=299851 ) photo album of the [email protected] group. *

Hello again, after sending the message I saw that I forgot the most crucial part in my BOM. 1x Relay (IM06TS) 1x Diode Array (BAS40DW-04) 0.1x Pin Header (W+P 952-09-080-2 cut into 10 pieces) 1x

Hello all, after quite a few years of absence from this group and from my trusty 7000-series equipment, I am back. The reason is quite obvious. I have a special measurement job which needs my

I NEED TO NO A RESISTOR VALUE IN THE RCTIFIER BOARD FOR THIS SCOPE MINE IS ALL BURNED UP ANE I CAN'T FINE THE HV OSCILLATOR TRANSISTOR. THANKS JOE

That seems highly likely. It might have been used to test SD sampling heads and the panel connections are from the interface to the heads.