开云体育

Hi Fabio, I carried out the following test ..... While pressing the Trig View, press also the Beam Finder (you should see the trace either stuck near the top or the bottom of the screen). While

Hi Dennis, thanks for your answer, could be a modified rectifier board? http://bee.mif.pg.gda.pl/ciasteczkowypotwor/Tek/050-1841-00.pdf Regards Miguel -----Mensaje original----- De:

If the Mouser part is a TO-247 case, the thermal resistance, Θj-c, is the same. When you get it you should see a metal (tin plated copper) pad embedded on the backside. Should work just fine if there

Hi John, No problem about the time... It's a relief for my mind to solve those puzzles. Some comments further down, just after your answers... Regards, Fabio Hmmm... Both things above together, may

Hey Stefan, This is typically because of leaking surface mount electrolytic capacitors on the A5 board. If you consult the archives, you’ll find plenty of information about this problem. Those

Thanks for the very comprehensive reply Fabio I will start to carry out the suggestions you have made, and will let you know how I get on 73 John

Thanks Harvey, all suggestions are very helpful as I said before I am useless when it comes to scopes and it a big learning curve!!!! From all the tests I have made there seems to be a complete lack

Hi Everyone, I'm definitely a newb to electronics repair, so I wanted to get some advice about my Tektronix 2467b. On startup, the scope errors out with one of two codes: "Test 05 Fail 04" or "Test 05

I have to replace the large power transistor on the A6 inter board the TIP35A one it was damaged from prior ill handling plus it appears to have been overheated at sometime as the case is deformed. I

Hello Guys, Many thanks for technicals comments, thats great ! I must keep your advice in a corner of my brain when I work on any stuff with digital signal. Regards Alain

Fifty feet ? Nothing, I got batteries ! LOL But if I ever need a cord I have no idea where to get one and I don't even have the DC cord. I reluctantly recommend a modification - to myself. Hell, it's

Hi all, Just found out about this group and I hope you all can help me out a little. I bought a 2215 off ebay (and subsequently got my $40 back no questions asked, so not only did he know it was

Whoa, why did that cap blow in the first place? I used my 7A22 and I remember that I was careful to keep the overdrive lamp off. I used the filters to remove LF and HF as much as I could so I like to

"It seems to be working with a good sine wave on both channels from the calibrator" ??? Is this the calibrator on the scope? If so, it should be a nice square wave. Are you using a scope probe?

Triggers are derived from the appropriate channel, or externally. They're processed, and that signal is used to trigger the sweep. AUTO triggers the sweep at a fixed rate in the absence of a trigger.

Hi Leo, For some reason the photos you think you are adding to your photo album today, are not showing up in the photo album! tom jobe...

Hello John, As a general rule of thumb, a thorough check of the Low Voltage power supplies, both for voltage on spec and ripple are both important and yet, an easy check. Not just because problems at

Hi Tom, Thanks for the documents, I added them to my 2215A paperwork and checked my scope for these mod's. I am in Spain, but based on the SN (204xxx) my 2215A was manufactured in the UK, so it's

On Thu, Aug 16, 2018 at 10:55 PM, Bert Haskins wrote: > > > > On 8/16/2018 9:43 AM, tom jobe wrote: > > Hi Leo, > > Thanks for the progress report, It's good to see that your 2215A > > repairs so far