开云体育

https://www.tek.com/manual/2215

R F Connection Therfc.com Gaithersburg MD Roy sends.

You're welcome! I learned about this part the hard way, too... ________________________________ Sent: Wednesday, May 16, 2018 2:03 PM To: [email protected] Subject: Re: [TekScopes] Power switch

I made a tiny bit progress. The file TEK 11801 DIAG.pdf mentioned by Bob Koller showed jumper settings to disable the power-up Self-test and/or Extended Diagnostics test. I tried this and then

Indeed! Thanks so much Jeff, very well worded description helped me find it's placement immediately. Keith

Plastic glue for building models as the French man submitted. Colle por plastique modèles. Works great as it melts the original and when volatils evaporate, all that is left is plastics in one piece.

This may not apply in this case but my old Time code nixie based generator was repaired with. Robber grommets. I found these st Ace hardware of all places nitbRadio Shack. YMMV

Let me suggest FCNP. I used them for shipping my Danaher 576 and 577, can look up the prices if you want

Hi Keith, That part slides along the top of the main board (if you have the scope on its side to access the power switch). it holds the hex nut that attaches to the screw that you can see in the

Recently picked one of these up in good, original condition. Seems to be an earlier one, with the serial being 5005. Pretty filthy, but literally has no dents, and does not exhibit any evidence of

Hi Nielsen, It is sort of a poorman's differential plugin. 1) It works OK at low to medium frequencies as long as both probes have been adjusted for their proper and identical risetime. 2) It works

ebay

That is a good test!

il used glue for plastics on exploded front cover offre à 465 worked création as string as original ,glue is named here in France Uhu colle tout ,smells simulation tout model plastic glue...it metls

Would anyone know how much a Tektronix 2712 spectrum analyzer and the 2707 tracking generator would have cost brand new? Thank you in advance. Mike K8MB.

Stupidly, I didn't look well enough before removing the power switch bracket on a 465 I'm working on, and this part fell out... I can't figure out where it goes or what the intended purpose of it is!

Hi Dennis, I'm afraid Craig is right, the prices over this side are crazy. Partly I suspect because there are far fewer around but mostly because prices on everything are way higher. Having read your

Dennis, there's no need to be stunned by the complexity of the 577 amplifier. It is quite complicated, but the reason is simple. The 577 senses true DUT collector current on the high-side, right from

On Wed, May 16, 2018 at 04:04 am, zenith5106 wrote: > > On Mon, May 14, 2018 at 04:44 pm, lop pol wrote: > > > > > Anyone have a source for ribbon cables? I would like to get a new one. I > know > >

On Wed, May 16, 2018 at 08:29 am, Fabio Trevisan wrote: > > Hi Lop Pol (again), > As others answered, it seems those tiny 5mm trimmer caps are prone to fail. > I had one of such failed on the