The Mouser lamps are rated for 100k hours. What are the ones you found
rated for?
?
Tom
?
toggle quoted message
Show quoted text
----- Original Message -----
Sent: Monday, October 15, 2012 4:37
PM
Subject: Re: [TekScopes] Re: 7B92 No Auto
trigger
?
For the 5 volt T-1 lamps Tektronix used for their illuminated
switches,
these are what I was going to order until I found a less
expensive supply
of them at a local electronics store:
On
Mon, 15 Oct 2012 20:20:54 -0000, "baltimora86" <acuffe@...>
wrote:
>Thanks
for your suggestions. I will check them and post back as soon as I have a
chance (probably later tonight). I can't believe how much time I'm spending on
this plug in, but it's so close to working, and I can't leave a puzzle
unfinished.
>
>Assuming I get it working, I need to replace most
of the light bulbs. Is there are known good source for the tiny bulbs used to
illuminate the buttons?
>
>--- In TekScopes@...,
"Albert" wrote:
>>
>> pdf page 26,
calibration steps j and k. Albert
>>
>> > How to adjust
the bias current (also for the other TDs) is undoubtedly described in the
Calibration procedure. I didn't read that part (yet).
