Hakan,
After knowing about the socket problem, is it best as PM to do a sweep of the sockets in the scopes and plugins? Is there a point where the sockets were better so replacing would not be needed? If so, what year? There are 8 and 16 pin sockets that will have this problem. I have seen some of the sockets have contacts that make contact on the sides of the IC pins. These will have small holes where the pins go in. Some dual wipe sockets that are taller to give more contact surface area work well. The MilMax machined types are better by being machined. Is the machined type the preferred type to use?
Mark
