On Fri, Feb 7, 2025 at 08:54 AM, Barry Breaux wrote:
Greetings,
What would cause this?
Thank you!
/g/TekScopes/photo/300558/3883505?p=Created%2C%2C%2C20%2C2%2C0%2C0
Scope seems to be in "chop" mode based on the position of "Display" knob. Are you applying the same signal to both channels? You could be seeing Ch1 and Ch2 together, I see that triggering is on Ch2, and Ch1 and Ch2 gains are not the same (Ch2 red knob is also out of cal position).
If you switch coupling to GND for one of the channels, pick trigger and input source for the active channel, do you still see two waveforms?
Ozan
