Hi Dave,
The 79xx scopes have different geometry on the front panel. The
display is lower down (smart), the power switch is in a slightly less
obvious place, I think the controls might be taller, among many
changes. The 7000 series had a common design style but the geometry of
the front panel and it's layout wasn't very uniform.
It would take a number of thin printouts of the outline to test fit to
make this work or you taking very careful and precise measurements of
some things. Or a 3D scan.
Keep in mind I am not trying to make a business out of this. I just
wanted to share the files and hopefully stop more innocent knobs from
being crunched by accident.
-Evan
On Sun, Jan 12, 2025 at 4:26?AM Dave Daniel via groups.io
<kc0wjn@...> wrote:
Will your 7704A cover fit on 79xx 'scopes? If so, I'd be interested in
having several (4 or 5) of them.
DaveD
KC0WJN
On Sun, Jan 12, 2025 at 00:40 evan foss via groups.io <evanfoss=
[email protected]> wrote:
Hi Folks,
I made a 3D printed cover for the front of my Tek 7704A. I was worried
about accidentally harming the switches while I move it off/on the
shelf. I could clean it up and share it but that would mean a large
reprint to test it and I wanted to gauge interest before wasting that
much plastic and electricity.
PS: I am planning to do one for the 11801 as well. Though I will
probably have to line that with copper tape or something.
Evan
