I see where Table 4-1, Item 3 (Signal Standardizer Calibration Fixture) states that "Calibrated 7000-series plug-in units with suitable signal sources may be substituted if lower performance is acceptable." I just don't quite see where the instructions outline how to set those up in place of the standardizer - particularly for low-frequency linearity and/or vertical high-frequency compensation.
Thanks,
Barry - N4BUQ
toggle quoted message
Show quoted text
----- Original Message -----
From: "n4buq" <n4buq@...>
To: "tekscopes" <[email protected]>
Sent: Thursday, December 30, 2021 5:11:41 PM
Subject: Re: [TekScopes] 7704A - Noise on sine-wave traces
I remember now that this involves adjustment of the LF Compensation. The
calibration steps for that calls for a standardizer fixture and I don't have
one of those. Is there a way to make that adjustment without a standardizer
fixture?
Thanks,
Barry - N4BUQ
----- Original Message -----
From: "Albert Otten" <aodiversen@...>
To: "tekscopes" <[email protected]>
Sent: Thursday, December 30, 2021 12:16:56 PM
Subject: Re: [TekScopes] 7704A - Noise on sine-wave traces
Hi Barry, please reread message 187015. Albert
