Your other problem is setting the Vernier where it is supposed to sit when you put it all together again! They don't all sit at 0.00, There is data about where they are supposed to read when the pot is at the extreme anticlockwise. If you have problems, just make them known here and you should get the right advice. Don't just adjust it to 0.00 - it is likely to be wrong.
Colin.
toggle quoted message
Show quoted text
-----Original Message-----
From:
[email protected] [mailto:
[email protected]] On Behalf Of Dave Peterson via groups.io
Sent: 25 November 2020 21:13
To:
[email protected]Subject: [TekScopes] Delay Time Position Vernier
Anyone know the trick to removing the Delay Time Position Vernier pot?
I have the fine adjustment knob off. Now what!?
Befuddled.
