Try this site and use any reasonable two part epoxy. If you hold it down
with tape as they suggest, even if the epoxy softens during soldering it
will be held down and harden again.
That site has guides for lots of types of repairs.
Farnell should have something you can use:
Regards,
Mark
toggle quoted message
Show quoted text
On Fri, May 3, 2019 at 12:44 PM cheater cheater <cheater00@...> wrote:
Again.... the solder connection is in place. it's just in air. It
needs to be glued down.
On Fri, May 3, 2019 at 9:36 PM Mike D <vfd.ninja@...> wrote:
First solder, then JB Weld.
Mike kd5rjz
On Fri, May 3, 2019, 2:34 PM cheater cheater <cheater00@... wrote:
What do you guys think of the DIP Tools Klebefix? (mentioned in my
last email). Has anyone here used it? Thanks.
On Fri, May 3, 2019 at 9:33 PM cheater00 cheater00 <
cheater00@...>
wrote:
Thanks. I checked them out. I wasn't able to find a place that
actually sells them - do you have a lead? It needs to be in Europe
because importing chemicals from outside Europe is pretty much
impossible.
The only thing I've been able to find so far this...
it says it's a highly electrically insulating, chemically curing (no
need for air), two-part epoxy glue. It says it's high temperature
resistant, but doesn't say what temperature exactly.
On Fri, May 3, 2019 at 8:40 PM Reginald Beardsley via Groups.Io
<pulaskite@...> wrote:
Take a look at these:
All of them are rated to above the eutectic of lead tin solder.
