On Thu, May 2, 2019 at 05:17 PM, David Berlind wrote:
this is such a timely thread because of my current need to get my four 7000
scopes calibrated and the fact that I managed to acquire the input
standardizer as the first part of my quest.
David,
The 067-0587-01 that you recently acquired is what Tek calls a *signal analyzer*. An *input standardizer* is a small module that is used to standardize the input impedance of 1 MOhm 'scope inputs. It's a small block that you plug on a vertical input's BNC socket. In essence, it emulates a well-adjusted 1 MOhm probe's output capacitance (to the 'scope).
Just trying to avoid confusion.
Raymond
Raymond Domp Frank