Very nice Reg, and very clever of Tom (that is, I didn't think of it!).
There is nothing special in the PCB. The 11801 can't know that there is a Dallas construction plugged in except for loss of memory after power down. Now could you confirm that you saw that specific battery error code T1331? Must be so.
Albert
This seems to confirm my previous suggestion that
toggle quoted message
Show quoted text
On Mon, Mar 25, 2019 at 12:55 AM, Reginald Beardsley wrote:
It booted!!!!
It recognizes the two SD-22s, knows it is 24 March 2019 though the time is off
by 2.5 hours. Two hours of which are Mountain time and the change in DST. It
reports 43989 hours of on time and 2033 power ups of which I probably did the
last few hundred.
Thank you Tom!
Reg
--------------------------------------------
On Sun, 3/24/19, Tom Miller <tmiller11147@...> wrote:
Subject: Re: [TekScopes] 11801 diagnostic help
To: [email protected]
Date: Sunday, March 24, 2019, 6:20 PM
Good point and that jogged a
memory. Try pulling the ram chips out of
the smartsocket and plugging them directly in.
See if it will fully boot
without the same
error.
