Hey Craig- try 'Rogowski'............ I have used them extensively, BTW
DaveB NZ-( the pedant!!)
toggle quoted message
Show quoted text
-----Original Message-----
From:
[email protected] [mailto:
[email protected]] On Behalf Of Craig
Sawyers
Sent: Monday, December 10, 2018 13:32
To:
[email protected]Subject: Re: [TekScopes] TIP: Current Probes ...
Design a Rogowsky coil. With the right design you can go from about 200Hz to
5MHz. Needs a wideband active integrator since a Rogowsky output is
proportional to dI/di.
-----Original Message-----
From: [email protected] [mailto:[email protected]] On Behalf Of
stefan_trethan
Sent: 09 December 2018 19:52
To: [email protected]
Subject: Re: [TekScopes] TIP: Current Probes ...
To answer my own question:
But only 47kHz, I'd like something like that with a couple hundred kHz....
ST
On Sun, Dec 9, 2018 at 8:38 PM stefan_trethan <stefan_trethan@...>
wrote:
------------------------------
Are there any cheap approximations of the Iprober 520 fluxgate
sensor current probe?
Maybe some sort of IC?
ST
On Sun, Dec 9, 2018 at 8:19 PM David Slipper <softfoot@...>
wrote:
I did look at making one with a Hall sensor - the electronics
isn't a problem but the difficulty arises (for me at least) in
cutting the slot in a ferrite ring to put the sensor in or even
splitting the core to make a clamp. I guess it's easier if you have
access to the right tools.
Any ways, this works well for me :-)
On 09/12/2018 18:52, stefan_trethan wrote:
If you only need low frequency the LEM brand hall effect
sensors, I believe Allegro also makes chip based ones, can be an
option.
Also remember you can put 10 turns through if you need more
sensitivity (insertion impedance permitting).
