开云体育

The knobs don’t have to come off. This is how I do it all the time. I usually take the case off when doing this but the scope needs a front cover which you may not have. But it if you set the face on carpet and carefully and don’t put alott of pressure on the controls of the front panel. Remove the rear screws 4 #20 torx and 2 #15 torx if all screws are still in rear cover. Then slide the case off the back. Then set on a table with the front Basel just off of the tables edge now or later as in this info. Take a small screwdriver and get under the edge of the strip on top of front bezel and pry it up moving along from one end to the other. Do this carefully as the little plastic tabs will come out . Then you now have access to all 8 #10 torx screws. 4 on top and 4 on the bottom. Then set the front just off the edge of the table and rock it easily to pull the entire assembly forward. The knobs and the knob retainers will cone off of the potentiometer shafts all together. Just work it forward easy mainly pulling on the screen side a little more. Then when putting it back on. Get the front started on the potentiometers, might have to move the knobs bu turning them a bit to get it to line up the carefully work the front Bezel back on. Then leave the bezel cover strip off reinstall the case and back then put bezel strip back on.
Removing knobs is very hard and 80% of the time they will break there internal clips.

Craig