I wish to add my two cents...
I purchased some power cord to replace the butched one on my 453 (w/ same wire specs) only to find that it was too big (overall size) to fit the cable clamp on the scope! I was forced to whittle the outside sheath down to get it to fit... I was not happy but did end up with a cord that included a plug with a cord holder.? I learned my lesson; never assume... I know, I know!
Phil
toggle quoted message
Show quoted text
On 7/25/2018 5:05 PM, n4buq wrote:
Okay, Jim. I took a second look and the power entry section is just a small part of the back panel so that would be a fairly easy replacement.
Thanks,
Barry - N4BUQ
----- Original Message -----
From: "Barry" <n4buq@...>
To: [email protected]
Sent: Tuesday, July 24, 2018 11:14:21 PM
Subject: Re: [TekScopes] Looking for Power Cord for 400-series Scope
Okay - I'll take a look again at that. Perhaps it isn't as much trouble as I
was thinking it was.
Thanks,
Barry - N4BUQ
----- Original Message -----
From: "Jim Olson" <v_12eng@...>
To: [email protected]
Sent: Tuesday, July 24, 2018 10:51:07 PM
Subject: Re: [TekScopes] Looking for Power Cord for 400-series Scope
The panel is easy to get off it is held on just two flat head phillips
screws
and the fuse cover box it lifts off with the cord attached you just need to
take off the wires the ground is bolted to the frame right at the cord in
and the white neutral wire is soldered to the fuse box and the power is
attached to a blue piece on the main board soldered too.
Jim
