Okay - I'll take a look again at that. Perhaps it isn't as much trouble as I was thinking it was.
Thanks,
Barry - N4BUQ
toggle quoted message
Show quoted text
----- Original Message -----
From: "Jim Olson" <v_12eng@...>
To: [email protected]
Sent: Tuesday, July 24, 2018 10:51:07 PM
Subject: Re: [TekScopes] Looking for Power Cord for 400-series Scope
The panel is easy to get off it is held on just two flat head phillips screws
and the fuse cover box it lifts off with the cord attached you just need to
take off the wires the ground is bolted to the frame right at the cord in
and the white neutral wire is soldered to the fuse box and the power is
attached to a blue piece on the main board soldered too.
Jim
