One of my cheapo HF miter saws crapped out recently, apparently from the main switch burning up. I went to their support website to see if I could find a new switch versus replacing the whole thing, and stumbled upon this unrelated recall notice:
I bought a couple of these sets years ago, and don't recall if or where I may have used some of these fuses, and am a bit worried. Thought I'd mention it here in case anyone has done the same.
It turned out that they didn't have the switches anymore, and it's a good thing. I ended up just getting a fresh saw on sale and with my 20% off coupon, and later found that the motor in the old saw had burned out, which is what caused the switch to burn up. If I had found a new switch, it would have been a waste. No regrets though, since I got a lot of use out of the old beast over several years, and worked it very hard lots of times.
Ed
