I will over the next few months have (well others are doing it for me)
literally tons of Tek HP, etc gear, parts, etc. We are hoping to find a
store/warehouse to rent for 6-12 months. thats how much there is.
What is your general interest ? BTW my use for the monitor is to hook up to
a TTY decoder (HF Modem). That has an X-Y output on the back. Not the same
but close !
I'm in North Portland where in Vanc are you ? I'm a bit busy this week have
family visiting and don't want to go over the bridge on the bad times
-pete
On Wed, Jun 13, 2018 at 12:55 PM J Mcvein via Groups.Io <jmcvein=
[email protected]> wrote:
I don't need much in the tek domain right now. You can have the 608 in
anticipation of future tek parts needs that I might have. It has no
options listed, BNC's out the back with no loop-thru, no graticule on a P31
(I assume) CRT. #B029502 I was using it as a display on a WJ spook set.
JimMc
On Wednesday, June 13, 2018, 12:28:56 PM PDT, Pete Lancashire <
xyzzypdx@...> wrote:
Are you looking for an even trade for the 608 for a 1101. Or just looking
for an 1101 ? As I clean out my estate I can put you on the Whiteboard for
one.
What are you asking for the 608 by itself and what options does it have
there were dozens of different boards CRT types gradicals Etc
On Wed, Jun 13, 2018, 12:14 PM J Mcvein via Groups.Io <jmcvein=
[email protected]> wrote:
Pete -
608??Have one here in Vanc, gathering dust.I could use a 1101 probe
supply
in the metal box..
JimMc
On Wednesday, June 13, 2018, 9:50:42 AM PDT, Pete Lancashire <
xyzzypdx@...> wrote:
Either the old 602 or one of the newer models. Only need one or two
megahertz bandwidth. Plenty of older Tek gear to trade or cash. Could
entertain an HP but being it retired from tektronix I have a preference
:-).
-pete
