Re: 1S1 Serial No. 100396 Guernsey
|
This sounds awfully similar to the behaviour of the 7S11/7T11 combination
toggle quoted message
Show quoted text
when it isn't triggering. It doesn't really semm to have an "Auto" mode, and dives off screen (downwards) if you don't get the stability/trigger controls set right. If find it very tricky to get a decent trigger every time I use them. Regards, David Partridge -----Original Message-----
From: TekScopes@... [mailto:TekScopes@...] Sent: 19 November 2014 13:29 To: TekScopes@... Subject: [TekScopes] Re: 1S1 Serial No. 100396 Guernsey Also, I have a couple of these 1S1's and get the same response from both. So, either they both share the same fault or more likely, I don't know how the heck to run my scope. I suspect the latter. But anything is possible I suppose. I am at first trying to determine which of the two plug-ins to restore. Then I can go from there. I do have an extension cable for the scope and plug-in, but had not wanted to move forward until I spoke with you all here. My next step was going to be just go through the CAL procedure and check all the power supplies in the PI and hopefully reveal something there. I would like to at least try to get this "trace to appear, as the restoration might be simple. HA!!! Thanks for the help folks. Cheers, David ------------------------------------ Posted by: d.garrido@... ------------------------------------ ------------------------------------ Yahoo Groups Links |
David C. Partridge