Also,
I have a couple of these 1S1's and get the same response from both. So, either they both share the same fault or more likely, I don't know how the heck to run my scope. I suspect the latter. But anything is possible I suppose. I am at first trying to determine which of the two plug-ins to restore. Then I can go from there.
I do have an extension cable for the scope and plug-in, but had not wanted to move forward until I spoke with you all here. My next step was going to be just go through the CAL procedure and check all the power supplies in the PI and hopefully reveal something there. I would like to at least try to get this "trace to appear, as the restoration might be simple. HA!!!
Thanks for the help folks.
Cheers,
David
