On Sep 27, 2020, at 3:28 PM, Michael King <mrmike17@...> wrote:

?

Google sunfish rudder dimensions 1971?and it will likely? pop up.? I made a cardboard pattern from the internet drawing, transferred it to a red oak board.? Cut it out, a bit of planning, drilling and sanding and four coats of urethane.? Works perfectly.? Pay attention to the over center hole for the spring attachment? so it?pops up as designed.? That was the only dimension the drawing did not provide.? A good afternoons work and a few days for the urethane to dry hard

Mr MIke

Sent from Windows Mail

From:?Doug Nelson
Sent:??Sunday?, ?September? ?27?, ?2020 ?3?:?03? ?PM
To:?[email protected]

So you acquired the new rudder cheek and used a new red oak “blank” to fit the rudder cheek? ?Might you come up with the dimensions? ?Interesting idea.?

Thanks

Doug

On Sep 27, 2020, at 2:51 PM, Michael King <mrmike17@...> wrote:

?

I made a completely new rudder when I converted to the new style.? The pattern iq quite different.? I found dimensions on the internet somewhere and made it out of red oak.? I sold the old one on Craigs List pretty quickly.

Mr Mike

Sent from Windows Mail

From:?Doug Nelson
Sent:??Sunday?, ?September? ?27?, ?2020 ?2?:?32? ?PM
To:?[email protected]

Can you convert an “old style” rudder blade to a “new style” rudder cheek?

Doug Nelson

On Sep 18, 2020, at 10:25 AM, Dave Redmon <LDRedmon@...> wrote:

?

Sorry, I sent it as a followup to my for sale listing earlier that same day--a listing with the same subject wording. I figured this list is small enough folks could figure?it out.

On Fri, Sep 18, 2020, 8:52 AM Mike Foster <mfoster@...> wrote:

FYI, I would never reply to a message like this.? There is no info, just a blind request to capture my email address.? Where is this Sunfish?? How much?? Thenmaybe I would know if its even worth the electrons to answer.? Thanks, Mike 76274.

On Sep 18, 2020, at 9:38 AM, Dave Redmon <daveredmon@...> wrote:

My email: ldredmon at

Sent from my T-Mobile 4G LTE Device
Get