开云体育

I had some difficulty removing the drive flanges and seals but I finally got it done.? I had to order two new circlips from Van Cafe as I destroyed one of mine taking it out. Then I installed the new seals, replaced the plastic backing thing, and finished that part up.? I drained the gear oil and was it ever dirty! ? But there were very few metallic particles on the magnetic drain plug.? I filled it with 3 liters of GL-4 conventional 80-90 gear oil but I’m still not sure that’s enough.? Possibly I’ll need to add a bit more.? I replaced the throwout bearing (release bearing) with a Sachs bearing, lubed the cross shaft bushings with dry lube and things there look pretty good.? I also installed a new reverse light switch as mine was toast. ?

?

Also I received my new high torque starter from Van Cafe.? I have the adapter plate from Westy Ventures.? So other than possibly adding a bit more gear oil, I’m good with the transmission.? The cross shaft bushings looked good and they were snug.? The main shaft had a bit of side to side wriggle but it was tight when I pulled on it.? The mounting rubber was also in good condition.? So I think I’m finished with this part of the conversion for now at least.

--

Warren

89 Westy?

88 Tintop

70 Westy