Re: Where to get parts for South Bend Lathes
|
I have looked at the belts I measured the old one hard to get a true measurement. The old one was? 59 3/4 length ? but it was stretched out. My adjustment was at the longest setting. The old one is 1/4 inch thick the new leather is 1/8. If I order one 2 inches shorter would that be right? Hate to just guess and not be right. Stamped numbers at the tail stock is CL8187RB on the plate on head is 210 46 R.?
On Friday, April 14, 2023 at 01:02:38 PM EDT, Rick <vwrick@...> wrote:
On Tue, Jun 9, 2020 at 12:00 PM, Bill in OKC too wrote:
I've got a Heavy 10L restoration project sitting here on hold for other reasons, but I tripped over this source of custom belts for SB lathes on a link from another forum and totally different subject. These may be the folks who sell on ebay, but I don't know for sure. They also mention Atlas lathes. I've not seen an Atlas that uses flat belts, but not by any means an Atlas expert, either. HTH!
Bill in OKC
Those are the same as they sell on eBay. I have one on my SB13. I think they are excellent.?
|
