开云体育

Sorry, skived and glued belt. I'd rather not cut it, if there is a way to change out the right-side bearing leaving it whole. Don

Pull out the pin, it should come free. Harry [email protected]> wrote: -- Harry Molwitz

Isn't there a current seam that can be disassembled vs 'CUT'

Anyone been able to replace the right hand undermount cone pulley bearing without cutting the drive belt? Don Verdiani, PA USA

Mark, I share your sentiments and experienced the same with my years of UPS shipping and delivery. I never want UPS delivery if I can avoid it.? We use USPS , but prefer FedEx. We got placed on the

I ship a moderate amount of widely-varying sized packages:? UPS store is usually a rip-off.? They're privately owned, and as @Andrei mentioned a UPS account is no good there.? Also, if you have

For semi improved "fail safe" tracking add an Apple Air-tag or the like to the package. It is amusing / amazing / disappointing what a shippers tracking tells you VS. what you can watch with an

I won’t use eBay again, going forward if someone wants it bad enough they can come to my door and pay cash or make their own arragements with a shipper local to me.? My last experience was shipping

I have a different story on FedEx, (They are probably all the same tho), I ordered several pieces of machinery that were shipped from USA origin to USA destination, via FedEx ground freight. 4 items

I have a different story on FedEx, (They are probably all the same tho), I ordered several pieces of machinery that were shipped from USA origin to USA destination, via FedEx ground freight. 4 items

I am in the process of cutting gearing to thread metric screws on my SB 9A. So, I need chunk of 2.125 brass round bar to finish. Should you happen to have a six inch length that is superfluous to you

Thank you.

I suggest you folks avoid the "UPS Store" like the plague. They will rip you off on the shipping rates. They charge way more than what UPS does and they don't accept an UPS account for

Closest city of any size is Madison, wi. The bed turret I'm asking $750 firm for and the taper attachment [complete except for binding lever] $800 firm $1500 takes the pair.? Buyer pays shipping. I

If ya have to lift it with a engine hoist? or anything for that matter make sure ya put a tag-line on the lathe . That line can be one of yer best friends day of move . Good luck , pic's or it

I have a South Bend 16 with the 12ft bed length option. I think the model is a 117H. I moved it to my shop on a 16' utility trailer. The previous owner bolted it to a shipping frame made of

What you need is a few bodies and simple basic equipment. ?Our 14.5" (1943 build date) was dragged out of a derelict garage using a pull lift & slings. ?We found a couple of old doors & bits

Hi all, expect to be picking it up on Sunday, with a drop deck trailer. I have a 10EE, so not my 1st big lathe move, but the pedestal is a new challenge. Initial questions. Is there a toe jack cut-out

Ok I put the DTS100K lever slide on the auction site, since it didn’t seem to generate a lot of interest here. Animal did you get your box o’ miscellany?

I can also be reached at brianpsherwood at gmail dot com i dunno why ka9egw at ka9egw dot com is being uncooperative