开云体育

That would be about what I expected. And if you're willing to ship, I'm willing to prepay, so you don't have to do it out of your own pocket. If you take Paypal, anyway. I'd be willing to use PP

True, but it is possible, as i bought 18 years of back issues (6-12 issues at a time sometimes 99C per and sometimes up to $6 per issue), from an eBay seller and have a few dozen shipping boxes to

Jim, If you were to box them up, a buyer could call USPS, UPS, FedEx and they could come to your house and pick up the boxes. It would increase your chances of selling the collection faster, and the

Hey Guys. Let's stop this daydreaming right now. I estimate these magazines would cost more than $100 to ship if packed in several boxes and sent out the cheapest way I could find. I have a lot of

I don't believe magazines can be sent via USPS media mail rate.

He should be able to send it book rate. Slower, but cheaper Al Sent: Monday, April 10, 2023 12:06 AM To: [email protected] Subject: Re: [SouthBendLathe] Home Shop Machinist Magazines

I forgot to mention. I measured the ends of the taper pin that holds it in place. It only just sticks through both sides. Large end 0.23", small end 0.20". Obviously you will probably have to

Hi Dennis & Fred, Please see attached for the carriage handwheel on our 1943 built 14.5 x 6' toolroom at the Golden valley Light Railway, UK. Might look tatty, but is actually in superb condition

If I understood correctly, he has 40 years worth of magazines there. It's going to be quite the effort to pack and ship. Quite a bit of postage, too. Worth it to me, but I'll understand if it's not

USPS Media Mail is very economical... but, You still have to pack them and carry them to the post office. Post office may want to verify the contents as well. . Good Luck

If you were willing to ship them, I'd buy them. Unfortunately, Oklahoma City doesn't seem to be local to Niagara Falls.? William R. Meyers, MSgt, USAF(Ret.) Aphorisms to live by:Good judgement

??? ??? If you can't sell them you may see if theres a MakerSpace in your area that would want them . ??? ??? animal

Hey Guys: I'm starting to feel my age lately and not been very active here for quite a while. ?I haven't gotten any response from C.L. ?so I thought I'd try here next. ?I have a very large

hi dennis i have a ? doz original sb hand wheels in various sizes what size do you need fred imsteamer21@... 914 720 5523 ________________________________

The insert geometry/chip breaker and maybe the grade could be what's giving you the issues with your current insert. A more positive chip breaker and a low speed grade may solve this issue for you.

Nice chart. Very self explanatory. Thanks much, I'll hang onto that for future reference. And I'll give them a call on Monday. Greg

Going to the railway shortly. Will try to remember to photograph & measure ours. Eddie

??? ??? I have a set of HSS inserts fro AR Warner & I think their fantastic . I don't know if the make a insert to fit your holder . Give them a call their sure helpful on the phone , or at

Thanks much for the tip and link Bill. I’ll check them out and play with the angle more. Shars actually said something to that effect. Said that some folks have had luck with that tool by lowering

https://www.arwarnerco.com. Talk to these folks, they may be able to point you somewhere useful. Might also play with the angle your tool touches the material. Might also want to try a different grade