Re: Grizzly Mill DRO Questions
|
www.amazon.com/DEWALT-DW872-14-Inch-Multi-Cutter-Saw/dp/B0000302QS According to this, 1300rpm. Bill in OKC? William R. Meyers, MSgt, USAF(Ret.) Aphorisms to live by: Good judgement comes from experience. Experience comes from bad judgement.? SEMPER GUMBY! Physics doesn't care about your schedule. The only reason I know anything is because I've done it wrong enough times to START to know better. Expect in one hand, expectorate in the other. See which one gets full first.
On Monday, November 20, 2023 at 11:19:40 PM CST, mike allen <animal@...> wrote:
Whats the RPM on that saw ? animal
On 11/20/23 9:13 PM, Bill in OKC too
via groups.io wrote:
I've got a chop saw sitting under a plastic bag in the
back yard. A DeWalt. Was designed for a carbide metal
cutting blade but came to me with a 14" cutoff wheel. The
correct blade costs more than I paid for the saw, but would
probably shatter the glass in a DRO scale. IIRC you can get
diamond blades that will cut metal, but I think they're even
more expensive. If you show up on my doorstep I'll give it
to you.?
It works as is for cutting metal but it's too loud and
sprays hot sparks everywhere. I used it once. Hosed down the
grass behind it, and put the bag over it. I think even the
grit disk is too percussive for a glass scale.?
Must be nice to have $$ to buy stuff like he has in his
shop. All pretty and new. :)
Bill in OKC?
William R.
Meyers, MSgt, USAF(Ret.)
Aphorisms
to live by:
Good judgement comes from experience.
Experience comes from bad judgement.?
SEMPER GUMBY!
Physics doesn't care about your schedule. The only reason I know anything is because I've done it wrong enough times to START to know better. Expect
in one hand, expectorate in the other. See
which one gets full first.
On Monday, November 20, 2023 at 04:38:36 PM CST, mike
allen <animal@...> wrote:
I somewhat get the feeling that Dale has a much better operating budget that myself . animal On
11/20/23 9:00 AM, ww_big_al wrote:
Try it at your own risk, but here is a video Showing Dale using a chop saw. Al-USA ? ? ? ? From:
[email protected]
<[email protected]>
On Behalf Of Andrei ? Great. Thanks. I was envisioning a diamond wheel on a dremel. ? Get From: [email protected]
<[email protected]>
on behalf of Mike Poore <mpoore10@...>
Sent: Monday, November 20, 2023 11:26:58 AM To: [email protected] <[email protected]> Subject: Re: [SouthBendLathe] Grizzly Mill DRO Questions ? It's been 3 years, but I believe I scored it with a diamond file and snapped it on a sharp edge. Could have used a glass cutter. Might have used a Dremel with a diamond cut-off wheel sold at Harbor Freight. On 11/20/2023 1:29 AM, Andrei wrote:
? |
Bill in OKC too