开云体育

Yes. Always go cheap. Good plan. Tony Tony Billera tony.billera@... 206 605 2650 linkedin.com/in/tonybillera Please consider the environment before printing this email. Thank you.

Does anyone have any good ideas for storing a Kayak on deck while underway? She's a 1989 -S24. We currently keep it roughly amidships at the shrouds, inside the lifelines. See pic. Was thinking of

Here’s one of the links but my box from the Loos gauge has the measurements and you’ll have to verify size of the wire or rod). It’s best to get it close to straight by measuring side to side

Guys, the point should be what suits your needs best then how much does it cost and how can you whittle that $ down. Allison Lehman Swiftsure Yachts allison@... Cell: 510.912.5800 Fax:

I don’t care. The Edson is better than a piece of wood. Tony Tony Billera tony.billera@... 206 605 2650 linkedin.com/in/tonybillera Please consider the environment before printing this email.

Ok, I didn’t go that far. Functionally they are equivalent. If you have the time, tools, and talent, the wood step is likely more satisfying to have and use. Being unretired, I still factor in time

Cheaper but not anywhere near equivalent. The Edson will last and perform as new for a lifetime. And then one can sell it. The hooks themselves are very high quality and about $20 each. Tony Tony

The $20 included wood and line. I had some left over varnish. Took may be an hour to make it not including drying time between varnish coats. As for time, I”m at that stage of life where my income

It is only $20 if you have the scrap wood, rope, vinyl strip, tools, varnish equipment and a skilled worker who values their time at $0/hour. Dave wrote: Yikes! $409 for a step? I have a boarding step

With a lift pump you don't really need to bleed. As per Pete's comment let the pump run for a minute then go ahead and start the engine. It may take a bit of cracking and run rough for a few seconds

The 4 point contact on the Edson step w non skid rubber buttons against the hull makes it very stable. The step has a very high safe load. Will not fail. Won’t rot. Included line is dynemms and clip

Just turn on the key and let the pump run for a couple of minutes until it’s it slows to a steady click-click-click. Assuming it’s a Westerbeast. Pete

I have replaced the lift pump and associated filters. New fuel line too. Before I restart the engine, does the system need to be purged of air? According to the manual, it is a self-bleeding system.

Just looking for some guidance.? Working on tuning the rigging on my 402 after this years launch.? I have a LOOS gauge? and would like to know what are the optimum values for tensioning the

Thank you so much.? Gary

Thank you so much? ? Gary

Thanks a lot

Yikes! $409 for a step? I have a boarding step made from a 6” x 16” piece of oak suspended by 5/16” line. I added a piece of vinyl weather stripping on the edge that sits against the hull and

I have one, it's nice because it's very sturdy and easy to climb on. Its significant, you need to take it down under sail and stow, its weighty and is not super quick like a transom ladder. If you're

Hi Mike My owners manual has basic instructions. Beyond those, I would consult the sail maker. Best Greg locke S34-2 338 Duet