开云体育

The Lewmar deck organizers on our 402 are in kind of sad shape. Sheaves are grooved, some of them are frozen, lots of corrosion on the aluminum upper part. Ideally, I’d like to replace those POS

Hi, i need some help with a dimension for a 1990 38 mkll with a wing keel, not easily found online! I'm a long way from the boat so can't measure myself. I need the height from the bottom of the keel

Peter: Snowy Owl has both a 120V Seafrost unit and an engine driven unit. ?I would like to size the new inverter to occasionally run the 110V refrigeration unit obviating the need to run the engine

Good morning Sabre enthusiasts, I have a customer that is replacing their Bimini ?on their 402 with split backstay. The pushpit is original, as are all mounting points, so I would assume that this

Once, when I unscrewed a hatch knob all the way out, a small spherical bead fell out. The knob locked the hatch much better when the bead was in place. Don’t know if it was OEM. Steve Wind Rush

Just put a big “i” in front of the H. People will figure you for the friendly type. Stephen Burns Kestrel. 362 Noank CT

I happen to be in Florida atm and went over to Second Wind to check it out since it's ~15m from where I am. Great selection and John was quite nice. They had a spinnaker for my 36 in great shape but

You can also try secondwindsails(dot)com -Darshan 34-2, Manhasset Bay

Sounds as if you have a Sea Frost 120V A/C unit as do I. I can run mine on pass through AC from the inverter and can disconnect from shore power leaving the 400 Watts of Solar, to charge the batteries

You can try Atlantic Sailtraders in Sarasota. Inventory changes often. They are on the web. --- Alan Pressman Phone; 941-350-1559 alanpressman@... [email protected]> wrote:

Thanks Jordan!

Good tip on the drain, Jim. Do you have the original Raritan heater? Arcadia's has a 3/4" tee on the cold water inlet with one end attached to the heater and a plug in the other end. I think this is

-- Peter Metcalf Pfmet@... Sabre 28 #312 Serenade Noank, CT link above failed so here’s a screenshot.

Of greatest concern to me when I did this job was risk of galling. Stainless is notoriously susceptible to this “cold welding”, a totally lay expression of what goes on but very descriptive of the

Bacon I believe in Maryland

Hello, I am looking for a jib and genoa for a 1985 Sabre 36 and wondering if anyone knows anyone selling used sails or knows a website that sells used sails. Thank you! Vivjan 1985 Sabre 36 |

I would make sure the new heater has a drain on it. Not having one has been an annoyance. Jim Gregory Sabre 402 #32 Milford CT

If you just want to re-torque the nuts, you just need to loosen them slightly, before re-torquing. It's not actually necessary to remove them. It's probably a good idea to remove them in order to

You are definitely overthinking it. Could any of those things happen? Yes. Do your research, learn from others experiences by searching the forum. I made sure the area was dry around the bolts, and

Hi Andy, I recently had a warranty issue with my Victron 12/2000/80/50 Multiplus Compact on my S38 Mk2. Victron shipped me a brand new replacement , but having just upgraded to 600Ah of Victron