开云体育

Carter, ON my system with a Vaspar ais and dedicated gps working with an ES7. The dedicated gps does show up as an alternative gps for the MFD. I don’t have it function as such. I use the internal.

Hi, folks, I just finished installation of a Raymarine AIS-700 and the Raymarine passive GPS antenna, the GA-200. I have the VHF radio (a Standard Horizon GX-2100) also connected to the AIS-700 which

It seems the yard ordered the wrong kit, somehow they specified the turbo version of the engine…. 48-YSP-3JH-A appears to be the correct kit for our boat. Balmar support is shipping the correct

I have one of these.? It's wonderful.? Slides back on the toe rail track and is completely out of the way when not in use.? It does, however, have to be carefully fitted to the boat so the two

Just looking for some guidance.? Working on tuning the rigging on my 402 after this years launch.? I have a LOOS gauge? and would like to know what are the optimum values for tensioning the

Thanks all, the stainless wire wheel chucked in a drill worked great!? All cleaned up and with a fresh coat of zinc primer.

Yes, my space is tight also, but I was able to squeeze in a Lasdrop drip less seal (they use a lip seal so are shorter.) Worked out well, you should consider it. BTW, since the gland is 1 3/4 OD, the

Barnacles and strainers: As a fresh water sailor I was feeling pretty smug about not needing to worry about barnacles on Arion's engine intake. Then I remembered how bad invasive mussels have been the

Very nice work Jeff. You have me inspired that this can be repaired. Cheers Bob S42 Vitesse Lake Ontario

Last time I contacted Balmar support I used email or the online contact form. The response was very quick, the next business day. Dave

We have the 105A alternator, and have been collecting belt dust every season, intended to tackle this a couple years ago but never got around to it. Ordered the AltMount adapter kit, specified my

4 or 5 inch RO sander with 120 grit mesh sanding pad works for the large areas pretty well. Also the mesh pads work pretty well to hand sand the corners etc. —Neil neil dot e dot russell at

A very serious complication with the dreaded maststep disease is that the rot can migrate to the main bulkhead, which is obscured by the furniture on main salon side and the Formica covering on the

Handle should be on the other side. If it’s missing you can put a crescent wrench over the tab that the handle attaches to - not the nuts in the picture. Replacement handles are available from

Bob - I also had cosmetic damage (black stains) and some rot in the plywood immediately around the mast step from water seepage. No structural concerns. My solution was to craft a teak and holly

I have that Scanmar ladder on my 38mkI.? It works pretty well.? We leave it rigged and folded up when not in use.? My boat does not have a stern boarding ladder.? We use the Scanmar for swimming

Here’s one of the link’s: you can also “borrow a handle from another seacock. They are replaceable but I service 5 years ago and have operated annually and they are still very much smooth and

Spartan seacocks, standard issue. The handle would be on the opposite side from the nuts. To service, follow procedure on Maine how to or the Spartan website. Len Bertaux Walkabout S38mkii Prides

Hi Under the? sink in my sabre 32. 1986 , I found a seacock that I think? is missing a handle .? ? ?Can I still check to see if it is functioning by moving the outer nut with a wrench? or would

Good to know. Thanks! It has been over 20 years since I looked into the USCG requirements. Can see some additional reading in my future. Brian Sent: Thursday, May 8, 2025 6:16 AM To: