I am Canadian and bought a 1988 Sabre 36 in New Jersey last Nov.
Boat surveyed above average. Broker has a marina and stored the boat and equipment over Winter for me.?
Just commissioned the boat and found a couple of issues, the Dingy and my Asymmetrical were damaged by a squirrel in what I assumed was winter storage. The never used Dingy has a 4 inch hole in the tube. I am told the estimate to fix is 800$ and will take until mid June. I hope to have it sailed close to home by then. Bought a RIB at Defender yesterday.?
Also, the Asymmetrical has multiple chew holes in the sock with some small ones in sail. Otherwise in like new condition.?
The rest of the boat is sound and I¡¯m happy with my purchase.?
This issue is not my fault of course and I¡¯m not pointing fingers. Just trying to see if there are any options.? The broker just sent me the address of the repair person.? I have Geico insurance.?
I thought similar experiences may exist among the group and was looking for guidance.?
I'm afraid I may be forced to replace my ignition switch on S28 Mk I. Does anyone have any idea where all these cables go to? I'm trying to replace it with a Colee- Hersee 3-position ignition switch and I have no clue which wires go where. I'll try attaching the photo of current switch.?
On May 15, 2025, at 9:41?AM, Bob Fields via groups.io <Fields@...> wrote:
Its time to replace our 4D AGM house batteries.? For how we use the boat AGMs are fine and I don't want to switch to Li.
Would anyone have recommendations for a specific manufacturer?? Many members of our club are using Interstate Marine AGMs and seem satisfied.
Second question I see? some manufacturers have switched to L lug terminals.? They seem awkward to connect.? My current battery has a bolt that screws right into the battery. Are there adaptors for the L lug terminals?
On May 15, 2025, at 7:07?AM, David Short, SV One Timer, 1997 362, Mt Desert, ME via groups.io <dhs.short@...> wrote:
?
I suggest you look into the Victron Super AGM's.? I put 3 of the 125
AH ones in a couple years ago & so far so good.
They pack in more AH for their size and claim a better discharge
tolerance.? Installed prior to a Newfoundland trip where we,
unfortunately, did not get to fully test them as we had a lot of
motoring.
You might fit their 230AH ones.
3 of the 125AH were $1175 del'd January 2023
Likewise Li does not make sense for my use.
On 5/15/2025 9:41 AM, Bob Fields via
groups.io wrote:
Its time to replace our 4D AGM house batteries.? For how we
use the boat AGMs are fine and I don't want to switch to Li.
Would anyone have recommendations for a specific
manufacturer?? Many members of our club are using Interstate
Marine AGMs and seem satisfied.
Second question I see? some manufacturers have switched to L
lug terminals.? They seem awkward to connect.? My current
battery has a bolt that screws right into the battery. Are there
adaptors for the L lug terminals?
?
--
Bob
S42
Vitesse
Lake Ontario
-- Dave Short SV One Timer 1997 S362 Mt Desert, ME
I suggest you look into the Victron Super AGM's.? I put 3 of the 125
AH ones in a couple years ago & so far so good.
They pack in more AH for their size and claim a better discharge
tolerance.? Installed prior to a Newfoundland trip where we,
unfortunately, did not get to fully test them as we had a lot of
motoring.
You might fit their 230AH ones.
3 of the 125AH were $1175 del'd January 2023
Likewise Li does not make sense for my use.
On 5/15/2025 9:41 AM, Bob Fields via
groups.io wrote:
Its time to replace our 4D AGM house batteries.? For how we
use the boat AGMs are fine and I don't want to switch to Li.
Would anyone have recommendations for a specific
manufacturer?? Many members of our club are using Interstate
Marine AGMs and seem satisfied.
Second question I see? some manufacturers have switched to L
lug terminals.? They seem awkward to connect.? My current
battery has a bolt that screws right into the battery. Are there
adaptors for the L lug terminals?
?
--
Bob
S42
Vitesse
Lake Ontario
-- Dave Short SV One Timer 1997 S362 Mt Desert, ME
Its time to replace our 4D AGM house batteries.? For how we use the boat AGMs are fine and I don't want to switch to Li.
Would anyone have recommendations for a specific manufacturer?? Many members of our club are using Interstate Marine AGMs and seem satisfied.
Second question I see? some manufacturers have switched to L lug terminals.? They seem awkward to connect.? My current battery has a bolt that screws right into the battery. Are there adaptors for the L lug terminals?
I¡¯m finally getting around to Rebedding my fixed port. ?Because I will probably need to rebed the other three in the not too distant future, I decided to purchase my own roll of CRL Glazing Vinyl. ?Thanks Phil and Andy for your kind offers.
I can verify it¡¯s a tedious job, and I appreciate everyone¡¯s helpful advice.
On Wed, May 14, 2025 at 9:54?AM Elizabeth Rhodes via <elizabeth.rhodes=[email protected]> wrote:
I have a Fairclough cover I've used for my S28II and all the stuff you need to use it, bought in 2016. It still has years of life but it's too much for me to handle now. It's at Savin Haill Yacht Club, 400 Morrissey Blvd, Dorechester MA. Let me know off list if you'd like to come get it. It would work with a mark I as well. In pic it's the one to the left. (elizabeth.rhodes@...). Fair winds, Elisa
I have a Fairclough cover I've used for my S28II and all the stuff you need to use it, bought in 2016. It still has years of life but it's too much for me to handle now. It's at Savin Haill Yacht Club, 400 Morrissey Blvd, Dorechester MA. Let me know off list if you'd like to come get it. It would work with a mark I as well. In pic it's the one to the left. (elizabeth.rhodes@...). Fair winds, Elisa
On Wed, May 14, 2025 at 9:44?AM Bill Graves via <elfowl77=[email protected]> wrote:
I see my boat in the registry under the previous (and original) owner's name.? What's the best way to update that?? Edit the existing entry, or make a new entry?? It may be useful to keep the previous owner records for tracking boat histories.
On Tue, May 13, 2025 at 8:28?PM Stephanie via <Shburgess1207=[email protected]> wrote:
This is an old thread and reply somewhat out of context. ?
While you¡¯re at it, please and as a part of our Group standards- use your email app or just go to the online auto signature by selecting More, Subscription, Settings and under your list preferences you¡¯ll find Signature and add your name, vessel model and Home port or Port of Call. ?
Thanks all, ?it really is nicer to know who is responding and reference who you are.? We are showing 1,100 members!?
Thanks to all offering advice!
--
Stephanie Moderator
Sabre 36, #67 Formerly Sabre 28-2, #289 Wilson Harbor, NY Lake Ontario
I see my boat in the registry under the previous (and original) owner's name.? What's the best way to update that?? Edit the existing entry, or make a new entry?? It may be useful to keep the previous owner records for tracking boat histories.
While you¡¯re at it, please and as a part of our Group standards- use your email app or just go to the online auto signature by selecting More, Subscription, Settings and under your list preferences you¡¯ll find Signature and add your name, vessel model and Home port or Port of Call. ?
Thanks all, ?it really is nicer to know who is responding and reference who you are.? We are showing 1,100 members!?
Thanks to all offering advice!
--
Stephanie Moderator
Sabre 36, #67 Formerly Sabre 28-2, #289 Wilson Harbor, NY Lake Ontario
On May 13, 2025, at 11:10 AM, Steve Myers - SV Wind Dancer, 1984 S34, Beaufort NC via <myerssl@...> wrote:
?
I've got the same tray that you were talking about.? Not sure what the original purpose was for it, but it holds a sponge for quick cleanups or drying out the bilge.
?
As far as getting in the back lazarette, at 6'1" and 235 lb. It's tight.? I only go in when absolutely necessary.? What I do to reach the handles normally is go upside down with my legs and ass hanging out of the lazarette.? It serves two functions, I can reach the handles and if someone walks by they can have a good laugh.