开云体育

Hey guys, Anyone know the numbers you use for setting PL on the shari? I wanna change the pl on my node, but forgot how to do it. Cheers, Jed

Hello, This email message is a notification to let you know that the following files have been uploaded to the Files area of the [email protected] group. * /Setting the RX Level in HamVOIP Allstar.pdf (

A friend built a SHARI node.? While the unit seemed to communicate with the Raspberry PI ok, and the LED lights indicated it was working, there was no actual radio communication with the node. Upon

Here is some more technical information about SHARI's USB connections. The USB connector nearest the edge of the enclosure is connected to the CM119B USB audio IC.? This is the device that Allstar

That makes sense. That was my other idea if I couldn't find a small enough hub, but I'll probably do that instead. I just want something a bit more compact and functional than my Pi-on-a-Motorola

You can get two (or one) short usb cables 6” and position it on top of the Pi. One is for the device and other is to program the device. -Brad mike@...> wrote:

While the world melts down due to COVID-19, and we wait for the supply of SHARI's to come back, I wanted to ask a quick question. Can the SHARI be used with a standard USB hub? I'm hoping to order

Our order for assembled SHARI SMT boards is now in production.? The good news is the bare PC board fabrication is complete.? However the order shows a projected PCB SMT assembly time of 55 to 70

If you have a Shari you want to part with, contact me off of the list. ?email good on QRZ. jb ?N4NQY

This sounds like a fun addition to my micro-shack and will give my unloved Pi 2 something to do (hi). Steve Matzura WB2KTV

Please refer to the SA818 Programming Manual located in the Files section of this group as you read the following explanation. The Channel Spacing option (0 or 1) is meant to select between narrowband

I have a Shari! Question on programming, The first option of programming is Channel Spacing... the options are 0 and 1, what is the effect of each?? My Second question is the Squelch Setting .. you

Hello, This email message is a notification to let you know that the following files have been uploaded to the Files area of the [email protected] group. * /SA818 programming manual.pdf (

Hi Doug, You can use CDCSS (DCS) as well as CTCSS.? The codes are in the NiceRF SA-818 programming manual.? I will upload a copy to the Files section. The programming manual also describes a "Close

Is there any way with SHARI or the sa818 to either use DCS or to turn on reverse burst to remove the squelch blast heard on the local radio?

All units have been spoken for. 73, Jim K8JK

I have 4 SHARI assembled and tested units available for sale. ?Each will cost $80.00 PayPal is acceptable, but will require the additional PayPal fee. You may inquire at my email address, kvo@...

My friend Sean (W9FFF) just put out a SHARI configuration / review video on YouTube. Check it out! https://www.youtube.com/watch?v=C7gVUUE66k8 -- Andrew Sylthe KC9ONA

Hey Steve, There are a few reasons why it would be nice to have a 2m version available: - I own a couple Motorola HTs that are VHF only. It would be nice to put those to use. - Maybe I want to run 2

Hi Andrew, I am delighted that you like your SHARI kit that I assembled for you.? We can thank W0ANM for the "818-prog" program to setup the SA818U and? Doug and his development team at HamVOIP for