开云体育

The following items have been added to the Files area of the [email protected] group. * /ASL3/Kits 4 Hams suggested SHARI settings for ASL3 in text format v1.03.docx (

I have uploaded a text based version also.

this file does not seem to have the needed information. Since this is all Linux Console based, it's much easier to cut and paste the actual text from the output? of the terminal than it is to make

The following items have been added to the Files area of the [email protected] group. * /ASL3/Kits 4 Hams suggested SHARI settings for ASL3 v1.01.pdf (

I have uploaded a document called "Kits 4 Hams suggested SHARI settings for ASL3" into the ASL3 folder in the Files section of this group. /g/SHARI/files/ASL3 Steve - N8AR

The following items have been added to the Files area of the [email protected] group. * /ASL3/Kits 4 Hams suggested SHARI settings for ASL3.pdf (

There are two documents in our "How To" folder in the files section of this group. One explains how to activate the COS LED.? The other address how to fix the SA818 programming with ASL3 and the

I purchased the Pi5 kit from kitsforhams.com and have it assembled. I have installed and setup ASL3 but i cannot get the node to work. I am getting error messages when applying the settings to the

Might be a bad power cable. When your checking the power supply voltage, move the cable around a little to check for for intermittent? broken wire.

And make sure the power supply didn't go bad too. I've had that one stump me myself with those.

First thing is check your power supply make sure it is giving you 5 volts and also it is rated at least 3 Amps. [email protected]> wrote:

Good morning to the group. This is my first time posting, so if I'm in the wrong spot, i apologize. So, over the last year or so, every once in a while ill go to use my node and I get nothing. No

try this Iax.conf - /etc/asterisk Ports to use Change bindport = xxxx Uncomment below, This will open system allowing multiple connections bindaddr = 0.0.0.0 [iaxrpt] ; Connect from iaxrpt Username

It is possible to configure shari with iaxrpt, I have tried to follow the instructions I found on the internet but without success I do not know where the error is [image: Mailsuite] Enviado con

oof! To bring this to a close, I followed the steps here as a guide and set up a VPN in the cloud that my node connects to. Hopefully this will resolve my IP address fluctuation issue.

Well then you should be very worried about the asnode.org domain then. Every node number resolves to its public IP. -Michael Sent: Monday, October 7, 2024 9:55 PM To: [email protected] Subject: Re:

Thanks for the tips. I spent several hours troubleshooting, now I have a better appreciation for how everything is stitched together. The root cause is that the mobile 4G hotspot (T-mobile network)

It is not your list that is the issue. It is in the node you are connecting to list that does not have you in it. Give it about 10 minutes then try again. Be patient [email protected]> wrote:

What version of ASL3 are you running? ?If it's any release prior to 3.0.4 then please update your system (there was an issue, now fixed, where connecting to 5-digit nodes worked but connecting to

Got it figured out. Have an issue with the antenna. Got an external antenna that is working.