this file does not seem to have the needed information.
Since this is all Linux Console based, it's much easier to cut and paste the actual text from the output? of the terminal than it is to make inaccessible screen shots.
Does the actual text for this exist anywhere?
Thanks.
?
?
Kits 4 Hams suggested SHARI settings for ASL3 (Version 1.03)?
Our recommended settings for the SA818 are very similar to those suggested for HamVOIP. In ASL3, SA818 programming is initiated by entering sudo sa818-menu at the terminal. The recommended settings, displayed by this menu, are as shown below. Of course RF frequency, CTCSS, squelch and Tail Tone are user choice.?
?
A screenshot of a computerDescription automatically generated
Note that the serial port shown is for a SHARI PiHat or PiZero. Serial port /dev/ttyUSB0 is used for a SHARI PiXX (i.e. Pi3U, Pi3V, Pi4U, Pi4V).?
Also, for a Pi5, the file config.txt located in /boot//firmware must be modified by deleting dtoverlay=disable-bt and adding dtparm=uart0 (located at the end of the file)?
The recommended simpleusb settings that differ from the default ASL3 default settings are as shown below. Of course the rxmixer (rxmixerset) and txmixer (txmixaset) settings are dependent on the radio used to access the node.?
?
A screenshot of a computer programDescription automatically generated
?
?
The Interface Tune CLI presentation of the simpleusb settings is:?
?
A screenshot of a computerDescription automatically generated
?
Note that the Interface CLI menu is reached by invoking sudo asl-menu at the terminal.?
?
?
