开云体育

I have the Shari PiHatU 52Pi running the Nodes-Venture ClearNode software. Everything is working properly for outgoing connections. However, despite I having forwarded port 4569 (UDP) to the IP

Got it! Thank you Steve for your reply. [email protected]> wrote:

Greetings, all: As I have migrated most of my multi-connection-holding nodes to ASL3, it occurs to me that it has never been satisfactorily proven how many connections a single node, without any load

Yes.? Because the Pi5 includes a debug serial port, a change is required.? The following from the construction and setup manual in the Files section of this group explains' You must use the Allstar

Hello all, I'm building an allstarlink node with a raspberry pi 5 with a Shari pihat and I can't program the sa818. The node works with the default sa818 settings, but when I try to change settings

I am running a yaesu ftd5 and have used the method documented on this site to attempt and set dtmf tones. Everyone of the codes except the 'A' tone work. I have adjusted the receive volume. Any

Yes.? Thanks for your response.? The problem turned out to be a problem with the registration of my -L callsign.? Fixed now and working well! 73 Jim.

Are you adding the extra 3 to the connect command?

Rich, Could you please post your configuration? I'd be interested in seeing it. I want to set mine up to do home as #1 and hotspot as #2 I'd be interested in seeing the differences. Thanks, Dean -

I currently have three different WiFi connections programmed into my Shari Node. One is base, second is for the vehicle and third is for my phone hotspot. A fellow member gave me a suggestion and I

I received this kit, assembled without much trouble and it works fine connecting to AllStar nodes. However, I can't get EchoLink to work. Specifics are below. Does anyone have suggestions? 73 Jim.

It works normally if I don't put broadcastify in it, so I am leaving it out. It works fine now with no issues. -- Rich KC0QA

Thank you all for your responses. I truly appreciate you sharing your experiences and knowledge -- Dennis - KD9ULM

The Pi5 is way more powerful than is needed for an Allstar node but we are hams so we like to experiment and several SHARI customers had emailed me to ask if a SHARI node could be built using the

For me, it has to be a software issue of some sort because I can connect the shari to another pi with a fresh install, put it in the same spot, and it works flawlessly.

Yes.. I have it set at 2 When i connect to a node and my node goes TX it stays keyed till time out. I have an idea as to what was causing it, but later confirmed with other test. Havent tried that,

The op was speaking of RAM in this case, not storage. You can run HamVoIP on an 8GB card just fine. It will only use 4GB of that space no matter how large the card is, unless you manually expand the

You know the SA818 is not a Motorola HT but more like a Baofeng... What's your squelch setting?? etc.... You may have something keying it...Could it be a birdie? When it keys up... do you hear dead

Scott KB3IQQ I and Patrick Disagree.? As a matter of fact, I have 2 RPI2's running Allstar on 2 repeaters for over 7 years now.. I use RPI2's, RPI3 A & B & B+'s? and a RPI ZERO W2? When attached to

Even though HamVoip says it needs 4GB, a 4GB card only has about 3.7GB, so you need to use an 8GB minimum.