开云体育

Simple solution:? Use a proxy on KD6CWI, that will resolve the problem.

Allen Many ISP's -primarily the wireless -cellphone based ISP's are what they call "Double NATed" menaing if you open a UDP port, it does not get you out to the "real world" as you ride in the

*Hello Folks - Thanks Scott KB3JQQ, Robert and Adam VA3AUM for the helpful advice!* Yes - by way of context fibre entered the neighbourhood and I took the plunge with Bell (in Ottawa, Canada) and a

Have to test, the SHARI isn't the most sensitive radio. The tone setup is mandatory to avoid disrupting other AllStar users.? On my busier conferences, I will boot poorly configured repeaters if I

The two main points: In modules.conf, make sure that the Echolink module is loaded. load => chan_echolink (change noload to load on that line). Next, configure echolink.conf with your node details

all you have to do is nano echolink.conf file and change the settings. make sure you are set for a -L from echolink and you will have a node number for it. yes there are instructions.

Hello everyone. Just got this email from EchoLink Admin. Seems they had an issue on my EchoLink on my Google Pixel7, also on my Microsoft Surface 5 Laptop and lastly on my ClearNode. Since I am not

Configuring echolink is pretty much identical on both ASL and HamVoIP, however, the echolink module in HamVoIP has lots of memory/code optimization and bug fixes that don't exist on the ASL version,

We use a T-mobile cell connection for internet for our repeater.? The connection is made using an Teltonika RUT 240 industrial cellular modem designed for uncontrolled environments. (we are in a

Do you not set offsets when programming the radio module?

1630 ft, inside a room that has stucco on the outside of the building. I could put an antenna right in from of the window, or possibly outside. -- At the moment-- there are no tones on the repeater.

Would that also apply to Allstar Link?

In theory, yes, but one has to question whether that's advisable.? There's a few factors to consider: 1.? Are you close enough to the repeater for it to work? 2.? Is the repeater properly

It should not need to worry about the offset. It goes directly into the repeater without going over the air at that point. As to tones, I suspect that the Shari would mute them. *Mark West*

Yes it can but you’ve also got to remember any hang times announcements IDs courtesy tones will also go out over the repeater unless you change it to zero duplex or anything will go out over the

When it is connected thru allstar it can

https://hamvoip.org/howto/echolink_howto.pdf

Hey Guys, I have a Shari node that's been running great for about 3 years. I was recently told that's it's possible to add Echolink in addition to Allstar. Has anyone written an easy how-to for this?

Can it do the offset and tones?

Yes. It can operate as a link node communicating with an analog repeater over RF. AB1PH/R is configured this way. -- 73, AB1PH Don Rolph