开云体育

Allstar obtains the correct time from the internet so the only reason I know that the clock could be wrong is if you are not connected to the internet.? Are you using a wired connection? To get to

How do I get to a prompt to edit files? I have to figure out how to get the tones to decode and how to set the clock somehow. It won't decode DTMF 3 from any of my radios so I haven't been able to

I agree that the SHARI setup procedure should not say " 16 GB required" and will change that.? I found a recent recommendation dated March 28, 2020 ?by Doug, WA3DSP for SD cards? in the HamVOIP

I propose a change to the document 'SHARI Allstar Node Setup and Configuration Guide'.? on page 2 the required hardware list suggests a SD Card 16G or larger.? this should be changed to 4G required

All of Allstar is messed up right now. The nodes are connecting and if you have a secondary Hamvoip registration then node information os somewhat displaying. NNX nodes are not even listed are now. I

No supply issues as far as SHARI is concerned.? Both the Pi3 and the Pi4 supply 1.2 amps max on the USB ports.? SHARI only needs about 500 mA in TX mode.

Allstar database is all messed up not sure why.. it started last night John WX5OU wx5ou@... John@... No trees were harmed in the creation of this message, but a large number of electrons

Looks like an AllstarLink issue.? The last node currently shown under Node Status and Maps is 50876.Shows up fine in the Allstar Link Node List. ---------------------- AllStar Link Node List

What does it mean if the SHARI web page cannot find status information about my node?? The node itself seems to be connecting and otherwise functioning properly? Thanks & 73, Ralph AA8RK

Hi Darrell, Are there supply issues with either the PI3 or PI4? What are the advantages of the Pi4 over the Pi3? Thanks, Ralph AA8RK

Electrically, at the USB interface, the Pi3 and? the Pi4 are identical. The only difference is the location of the USB ports to accommodate the new location of the USB ports in the Pi4.? If you plug

That idea has a lot of merit. :-)

My understanding is the SHARI's are the same. The only difference is the USB ports are flipped so the SHARI is right side up for the PI you are using without blocking the Ethernet port. If it was me,

I actually didn't order anything. I know that sounds weird. I wrote about ordering one back in February, Shari replied to my message, and I either didn't receive it or accidentally deleted it. I wrote

I noticed that when ordering, and ordered the appropriate PI.

Hi Steve, there are four versions of the SHARI. UHF/VHF for the PI3 and UHF/VHF for the PI4. Darrell - 73 de W8DSB "In God we trust, all others we monitor"

I bought, and am very happy with, two pre-built nodes, one each for VHf and UHF, and they appear to be specifically for the Pi 3. I own a Pi 4. While both units work perfectly, did I buy the wrong

Neil, I did some poking around in allstar (HAMVOIP version) and found these two files. This is from a allstar node that has a working SHARI attached. Maybe you can compare to your files and see if the

This was a fully assembled and programmed Sherry and it appears to be working based on what I could find from a play space Dash L & LSUSB Sent with Speaking Email. Please excuse any dictation errors.

Neil, did you buy the fully assembled device or did you purchase it as a kit? I only ask because if it’s a kit maybe the USB connector is not soldier correctly causing it not to be detected by