?

Hi:

The file that plays after Allison slowly and painfully says "I... P... address..." the way she slowly and painfully said everything, before the IP address is spoken, is your normal node ID.

If you go through the standard HamVoIP setup procedure USING THE FIRST TIME SCRIPT, and you told it to use a voice ID, this file will exist at /etc/asterisk/local/node-id.gsm by default. You can change the referenced ID to something else in /etc/asterisk/rpt.conf using the idtalkover and idrecording directives.

It just happens to play the ID since the node keyed up to say "I... P... Address..." and that is the first transmission from the node after bootup.

So, unless you want your node to ID with your node number instead of your call every <x> minutes, where <x> is the duration set in rpt.conf for the ID interval (not recommended for obvious reasons, unless it is part of an ID also containing the call)...

?

I recently downloaded the RPi-Z2W-2-3-4_V1.7-01 image to program a Raspberry Pi Zero.

The Pi Zero works but I want to make a change.
When booting up or when the Pi Zero makes an announcement, the Pi Zero announces my callsign.?
I would prefer that the node number be announced.?
I am looking for the file or files that need to be edited to make this change.