Hey May just have to plug it with a temporary brass wheel until a spoked wheel is found or fabricated most likely? I would be inclined to get a brass plug cut to diameter and then hand drilling out the spaces and then hand filing to finished. Better than nothing Better than letting the engine sit on a shelf forever? I think I could do a pretty respectable fabrication? S scale man Roger On Dec 16, 2024, at 8:34?PM, Mike Swederska via <MikeSscale=[email protected]> wrote: ? Austin, I just went through all my driver inventory looking for that 1.25¡± diameter and came up short. That is a very large driver. Sorry I couldn¡¯t help. -- Mike Swederska Meramec Valley Lines Modeling Mopac equipment in 3/16 Don't let perfection get in the way of good enough! Keep model railroading fun!
On Dec 16, 2024, at 8:34?PM, Mike Swederska via <MikeSscale=[email protected]> wrote:
? Austin, I just went through all my driver inventory looking for that 1.25¡± diameter and came up short. That is a very large driver. Sorry I couldn¡¯t help. -- Mike Swederska Meramec Valley Lines Modeling Mopac equipment in 3/16 Don't let perfection get in the way of good enough! Keep model railroading fun!
