开云体育

Thanks Doug, when you say : "...write your own code to send commands to the Zero? and process the returned ASCII data" , do you mean to interact with ZERO via serial TTL port using those commands ?

Hello Alex Much appreciate the help. Ill follow up to let know how it goes. Tom L

A flashing analyzer screen indicates that the analyzer is in bootloader mode. The correct way to take the analyzer out of this mode is to successfully complete the firmware update. Try manual firmware

Dear Thomas, You can download the FlashRWE utility here: https://rigexpert.com/files/FlashRWE.exe <https://rigexpert.com/files/FlashRWE.exe> But alas, this utility does not always work stably with

Hello when I purchased my AA-600 back in 2014 I loaded an app called FlashRWE? This app would allow me to view / move / manipulate files I saved on my analyzer. I'm moving to a new PC and am trying

When I turn the unit on version 1.13 is displayed. And the only way I could unlock the device from continuously flashing was to remove the batteries.

Hi! What version of the analyzer's firmware was before the update? Yes, important information. I recommend removing the batteries from the analyzer before upgrading. In this case, the update process

Seeing your post, I checked my AA-35 and found an update was available. The first attempt to update failed - both the Windows app and the AA-35 "locked up." The second attempt succeeded. I was

Looks like the library overhead is too high for your application.? My suggestion is to forget the library and just write your own code to send commands to the Zero? and process the returned ASCII

I just got a new Zoom AA-35 a couple weeks back and decided to see if there is an firmware update for it. The update software says that there is. So I tried to proceed with the process by letting the

I am on a project for my mag loop antenna controller (it moves the capacitor motor to tune) for HF bands, but the time needed to sweep via the "ZERO.startMeasure(temp)" arduino library is too slow. I

What is the latest version of AntScope2 for the AA-55 Zoom?? Any new features in it? Roger

Hi Scott. Definitely, the resistors are fried. Its needs to be replaced. In general, in this case, it is recommended to replace all seven bridge resistors. Three resistors 51 ohms. Two resistors 27

Ok Alex, Do both of these look bad to you ? I think the one with a 5 on it looks cooked. ?The 2700 looks suspect as well. What do you think? N2OG Scott

Alex, I downloaded the APK package for AS2 1.1.15 for Android to my Samsung Galaxy Tablet. Install went fine. BT connect to the AA-55 Zoom BT went fine. I did a few measurements. They were reasonably

OK, a couple of observations.... Doug, I DID use the AS2 that Alex specified in his post above in my test. But, I had to remove ALL remnants of AS2 and the AA-55 Zoom from my Win 10 Pro x64 machine

I have tested the new Android app on my Android tablet.? There were no data transfer errors and the speed was the same as I measured on Windows 8.1 However there were connection issues.? Sometimes

Alex, I have tested the new Antscope 2 beta program with the beta release firmware 1.26 for the AA-55 Zoom. Other beta testers should know you need to install both in order for Bluetooth to work. The

Connecting the analyzer to a PC will not damage the bridge. But sometimes (very rarely) it can cause a malfunction of the power circuits. But in this case, the analyzer will not turn on at all.

Alex, I do hope your Covid-19 symptoms are better. I have downloaded the Flashtool, binary file, and AS2 1.1.5 to my Thinkpad with W10 x64. Same as last time. I flashed the firmware to my AA-55 Zoom