开云体育

If Antscoope2 does not show AA-600 in the USB port list. Make shore that the AA-600 is turned on and connected via USB. Then reboot your MAC. Now the USB connection should bee restored and will show

G'day all I used my Stick Pro with my laptop, a Panasonic toughbook CF-19, Win7, very successfully at our club's antenna building day. When I started it all up again a few weeks later ,the Stick Pro

Hi I am trying to set up a new AA-30 with my Arduino Board, I have the Arduino software installed and copied the simple repeater code but I get an error code when send it to the board I see the COM 9

David, Another thing to keep in mind is the inductance of the leads on your capacitor.? It is about 5 nanohenries (nH) per cm or 13 nH per inch. This has a considerable effect depending on what

You need a proper test jig in order to measure components accurately.? I wrote a post on this topic some time ago. /g/RigExpert-Family/message/352

Yes the AA55 works great on my HEX and 80 meter dipole

Alex yes I'm using only one coax. I just re-checked and now I'm getting 1:79 on 40 and 1.35 on 30. Yesterday we had high winds maybe a branch . Either way it's working now. Thanks for your replay

Thanks Mike, makes sense.? I was over complicating things I think.

Good video about this topic: https://www.youtube.com/watch?v=9QRpWjLFApA 29.04.2021 22:00, Tom Parkinson пишет:

AA-55ZOOM and up - https://static.dxengineering.com/global/images/instructions/dxe-osl-cal-set.pdf [email protected]> wrote:

Hello, *AA-35 Zoom* does not have a built-in OSL calibration function. 29.04.2021 19:52, David Dybas via groups.io пишет:

I dont see any means for doing an OSL calibration of this model unit. But I will keep searching. BTW that is a great idea ...I use that approach with my Array Solutions VNA.

I have an AA-54 and assumed that the "system impedance" was the impedance output of my radio, which, is 50 ohms. My my measurements are in agreement with the settings of my tuner so I think that works

It might depend on the capacity of the units compared to the fixture used to connect them to the analyzer. The fixture's capacitance would be included in the measured capacitance unless calibrated

Dear Dave, It is necessary to measure the capacitance of the capacitors (or the inductance of the coils) at the frequency where the value of the active resistance is about 50 ohms. That is, the

I'm an old guy new to analyzers and recently purchased an AA-55 Zoom which I'm still getting used to using. ?Can someone explain to this old geezer what the analyzer is looking for when setting

Hi All, I am measuring 1% tolerance Silvered-Mica Capacitors which I purchased new from a large supply house.? ?When I use the AA-35 to measure these capacitors, of various capacitances,? the AA-35

I agree a fanned dipole of three should read as 3 separate antennas. Sent: Thursday, April 22, 2021 6:39 PM To: [email protected] Subject: Re: [RigExpert Family] AA55 Zoom fan Dipole

It should see both dipoles just the way it is. I suspect you have a bad connecting cable or something is wrong with your AA-55 Zoom.? Have you tried connecting a dummy load to see if it is close to

Hi Cody, Are two dipoles connected to one coaxial cable at the same time? Scan SWR (button 4) in the entire range and show a photo of the resulting graph. /Regards, Alex/ 23.04.2021 01:26, Cody via