开云体育

Mike, I was going to ask you if hamclock was installed among the other questions I could have asked. Did you try uninstalling it before the reinstall? 73 Seán ei2jmb

Good morning Sean, I never did try that but in the end I re-formated the SD card and did a clean install. I only use my setup for Hamclock so no big deal no data per say was lost. All is working great

It depends on the M.2 'HAT'. It depends on the 'HAT' interface. The RPi4 can and does use M.2. The RPi4 Argon case, for example, uses a USB M.2 board but you are correct that only the RPi5 has the

Rpi4 cannot use the M.2 hat. It has no externally accessible PCIe bus ?Get BlueMail for Android ?

Tell synaptic to fix the errors before removing.

I’m trying to remove WSJT-X Improved from my Pi 400 running Bookworm. I get the following when trying to remove/purge: pi@KO3F:~ $ sudo apt remove --purge wsjtx Reading package lists...

I’m trying to remove WSJT-X Improved from my Pi 400 running Bookworm. I get the following when trying to remove/purge: pi@KO3F:~ $ sudo apt remove --purge wsjtx Reading package lists...

RPi4 and RPi5 can use the M.2 Hat and have an M.2 SSD installed. I have one of these on my RPi5 with a 256 GB M.2 SSD running RaspI-OS 64-bit Bookworm. Larry - AC8YE Sent with [Proton

Does it happen if you login as another user? Seán ei2jmb

Hi Tadd, Ok, I understand.? Adding a wart on the side of the existing controller might cause more trouble than its worth.? We already had the Raspberry Pi in place, and an easy spot to tap into the

I found this article about TheLinkbox that may turn on the idea/rabbit-hole light to try out. Your problem may be a power issue. Just my 2 cents. Good

Greg, that is pretty close. I am hoping somebody will integrate the feature into the controller, with or without Direwolf. I pondered using a separate Raspberry PI and Direwolf, and letting the

It has nothing to do with the repeater, (which is an MTR-2000). In testing the software we found that the GPIO output that controls the PTT line never unkeys if the COS signal is held active longer

Check out Jeff Geerlings page. He has a list of tested NVMe M.2 drives that work or don't work with the Pi5.? Also, if you set it to PCIe x3, you are probably getting read and write errors.? Go back

DNS. I doubt this is a matter of the storage medium and more of an issue with different OSes with different configurations on the different media: - in a terminal window, run "sudo dmesg" and

Using a Pi-5 and 64 bit Bookworm.? Seems OK booting on SD card.? Internet extremely slow booting on SSD. Several attempts to make it work.? Latest was using SD card and updating it.? Then write

Ah, yes. We have had the same problem! I bet every one of those radios is a recent Yaesu model - their UI is really easy to mess this up without knowing it. What we did was to add

I am pondering using a Raspberry PI for a repeater controller. Until now I’ve been a firmware bare-metal repeater controller builder. A local repeater has a problem in that people keep leaving

I was actually planning to use my RPi 4B. I have only seen one ssd interface card.? I did buy a metal case from Amazon that was a little taller than most cases and included a heat sink and fan as

Hello Bill, With this being the issue, it be helpful to know what you are using for a repeater. You may also want to ask the question at the svxlink at groups.io? /g/svxlink Mick