开云体育

Hi, John: ?Please, in your own words, tell us what you want. Please use nouns, rather than pronouns. i.e. Avoid 'this', 'that', 'it', ... ?The 'Subject:' line in the thread you used may be

Some documentation/resources in the wiki https://github.com/dslotter/HamPi/wiki -- Dana Simmons https://linkedin.com/in/dcsimon KN4BEV

OK, I loaded it up on my Mac. Make sure you have an unformatted SD Card (delete all partitions (and MBR) if you have formatted it and the Etcher tool doesn't recognize it. If you have the .img or .tar

What radio are you using? Unless it's a very new radio, you can probably just install the hamlib version from your distro's packaging system. From there, direwolf should be happy. --David KI6ZHD

I believe that by insisting we run the research software he is violation oi the GNU licences that cover LINUX and BOINC. The GNU licence says :- "The licenses for most software and other practical

Also I failed to mention I do not see any output when I transmit, or at least the ALC and PO dont really register, modulation is set to 55 with no change in increase of modulation. There are so many

I am using WSJT-X on a pi4 with an ICOM 7100 and after I transmit the decode freezes as well as the waterfall, any thoughts. Same setup on a PC has no issues.

Jim, Apparently, the WVARC guys are not initializing the Teensy before shipping. Disable AX.25 again, and use the pitnc_setparams program to set the values on the TNC like so: For 1200

When I try that it says Disk not readable. John

In his original announcement there was a like to the torrent and several other links. He has it located on some of his Beta Testers Google Drives. A, K, N, W I used the K

Go to: http://hampi.radiowaves.ca -- there are readme and install files as well as the tar file. -- John D. Hays Kingston, WA K7VE

I figured it was time to get rid of my KPC-2 for packet and go with Direwolf. I'm running a Pi-3. I went ahead and installed Direwolf and forgot to install Hamlib first. The Direwolf manual says that

Where can I find the new Raspberry Pi file as a .tar? ?I do not do torrents, ?What is contained in the updated file to make it worth me going after it?

Either the .tar or .img file as source SD card as destination. [email protected]> wrote:

You don't need to format the SD, just let Etcher copy it.

you don't format it before you use Etcher. Etcher takes the HamPiV1.0.img.xz file, uncompressed it, and writes it bit by bit to the SD card as an exact duplicate of what it came from.

OK! I have the HamPi_v1.0Tar file. On Mac. i double clicked it, and a couple of minutes later it has decompressed into a Folder HamPi v1.0 by W3DJS Balena Etcher is ready and the SD card is in

Don Let me try this. I had the same challenge wrapping my head around a PiGate install with a TNC-Pi 9k6 board. Mark’s comments are spot on. Create a clean image of PiGate and install that

Thank you. That did it. I changed TX delay to 350 ms and baud now 1200. Thank You. *Don Poaps* *New Westminster, BC* *VA7DGP DATA* *VA7QU VOICE* *Winlink: va7qu@...

TNC Software Version 11 01 TXDelay - Zero means use ADC 50 02 Persistance 64 03 Slottime (in 10 mS) 40 04 TXTail 30 05 Full Duplex - Not