开云体育

I have a rpi 5 running the bookworm os. it receives on wsjt-x with alsa.. on the input choice. I am using sysdefault on the output choice, however I am not sure this is actually transmitting although

You're welcome, Dave. Although I've not used that particular product, I have been very favorably impressed with the design and operation of several other GeekWorm products. Best

I've purchased a couple items recently. Although they supply 3A instead of 5A, I haven't found 5A necessary for the Raspberry Pi 4B. They work fine. The one wth the USB type C plug fits directly to

Thanks, Larry. I'm a little slow to respond but this does look like a good product. At the time we were making a decision, the Pi 5 was still a little hard to get. It is certainly something I would

For sale: Unpopulated Radioberry V2.0 beta 4 and Preamp boards (1 of each) $15 for the pair, including postage to U.S. included. Made by JLCPCB. U.S. only. I have five pairs. Private message me.

While this is a response to an old thread, I think it's relevant. I just received a marketing email fro GeekWorm that includes a discount on their X1203 5.1V 5A UPS Shield for Raspberry Pi 5

I have done an extensive search on internet for solutions to the problem I have been having. It seems to be specific to the FUNCube Dongle Pro + and GQRX on the Raspberry Pi. It seems to be a problem

That line is already in the config.txt file. So much for that. Zack

The problem I have had is evidently a common and well-known problem with the FUNCube dongle on GQRX. After some searching, I found a site that outlined a repair. It said Add this line to the bottom

Also, the current at 5v will be 2.4x the current at 12v. ?Get BlueMail for Android ?

Disconnect the USB keyboard and mouse to check the difference in current draw with each of those. And remember, you are limited to 1.2 amps TOTAL current combined from all 4 USB ports ?Get BlueMail

https://www.amazon.com/s?k=usb+current+meter&crid=13PO0S4CLYQCU&sprefix=usb+current+meter%2Caps%2C135&ref=nb_sb_noss_1 Chuck N7CHS

I got curious and used a 12 to 5 volt adaptor with a USB-C plug on it. I have no way of measuring the current on a USB-C line. But I can measure the current on the 12 volt line. Current at 5 volts is

So I followed the instructions https://sourceforge.net/p/fldigi/wiki/debian_howto/. Everything looked great, program seemed to compile. I? get all the way to the last step to install : make && sudo

Thanks! I am going to give it a try this weekend when I have a few min to go threw it methodically. I will certainly update you on my progress! Mark N2UEM

Most SDR dongles use quite a bit of current. The issue with the FUNCube causing loss of mouse is very typical of what happens when you exceed the power capabilities of the USB ports. You need a

I just recently joined this group. I'm new to the Raspberry Pi and actually new to Linux. My original purpose for the Ras[berry Pi was to use it as a spectrum monitor for the IF of microwave

One of the issues with Linux is package management—meaning the software isn’t always kept up to date by the volunteer package owner. It’s pretty easy for the software to fall out of date,

Sorry, FT-710.

FL-701 IS in the latest version. (2.0.05) Get it from the FLDIGI website, not from your out of date repository. Nigel A. Gunn, ///shoulders.outwards.resolutions tel +1-937-971-0366 Amateur