开云体育

For some reason, I can not see the bottom of the config window for Pat Menu.? This is the only screen that appears to display longer then the desktop can display. Basically, the bottom is cut off and

Care to enlighten the rest of us that are having difficulty getting it to work? Any particular steps to get it to work, like having it recognized by linux and how to change the port and/or port

Hello Pete Yes, I use a SCU-17 with both the Pi 4 and 3A+ connected to a Yaesu FT-891 and FT-817nd. Works very nicely with wsjt-x and fldigi. 73 Glen G0SBN

G'Day To All, Has anyone successfully used a *Yaesu SCU-17 USB Interface* with a Raspberry Pi ? Pete VK4CCV

Depending on which board you purchase the appropriate firmware is pre loaded.? For instance if you get a TNC configured with the Raspberry PI headers then it has firmware loaded to interact with the

Not yet. We have a schematic and bill-of-materials. KM4EP is building a prototype but he has several related projects that are keeping him from getting to this. Tadd Tadd Torborg

Both versions have the same checksums. There is no difference between them.

I didn’t use the BitTorrent version but the alternative. So later I will do it all over again with a BitTorrent verspinn. I will keep you informed.

That’s a thought. ?I simply pulled the USB cable out of the Dell, and put it in the Raspberry. ?So, no problem on the laptop, and it has a torroid on it now. ?I’ll take a look at power level

This may be silly but could RF be getting back into the PI? Try a few Toroid On the USB line.. also try lowering the power to see if anything changes. KO4Lloyd

I have run into a problem with my new Raspberry Pi 4 and WSJT-X. ?Just got the Raspberry. ?Trying to set up WSJT-X, making all the configuration selections the same as what I have on my Windows

I am observing an issue on RPi 4 and have passed to the engineers for validation. [email protected]> wrote:

I had a few minutes and loaded up the bittorrent version of the image, and burned it to a 32 GB SD card using the Balena Etcher program. I first placed it in a Raspberry Pi 3B+ and booted it up. Did

Hey Tadd,? I like the idea of this linear supply for the Pi, just wondering how this project is going and if you have any circuit boards available for sale. Regards Joe - VK5EI

On 27/6/20 4:17 am, Don Poaps wrote: AX 25 services issues pi@raspberrypi:~ $ cd pitnc pi@raspberrypi:~/pitnc $ sudo systemctl

Don, If you will be using the PiGate image, there is nothing for you to do except plug the TNC into the Pi, load the image to an SD card, insert it about boot. I don't know how the TNC-Pi9k6 from

Don, /etc/default/ax25, NOT "I didn't have this file in /dev/default/ac25" Make sure you are editing the correct files. MarkKD0QYN

For loading the Teensy, go to the old Pi-TNC site and look at the manual for the PiTNC-9k6 there. It has instructions for compiling and loading

Two Dons – go figure ? I use Putty as SSH as well as VNC – which is why I was sort of curious why turning off Secure Shell seemed to work as I didn’t connect that way. Unless it reserved

Hi John, it is the generation 1, I suppose. It has the little connector for the GPS on the same side as the 6-pin connectors. Order number 5482, Nov. 19th 2018