If you hold the board with the Pi edge connector to the top and the
USB connection to the left then the jumpers are fitted horizontally
on? the right hand pair of pins.
73,
John G8BPQ
On 04/12/2020 19:01, Mike - KB0FX
wrote:
toggle quoted message
Show quoted text
Matt - Thanks for the quick response! I have
verified that logging is turned off to the serial port. I am
trying to run?
pitnc_get/setparams
and it just keeps trying and trying. The V4 board JP3 &
JP4 heards on have three pins. I have pins 1 & 2 jumpered
on both headers. Is that correct??
73
- Mike - KB0FX
Make sure you have enabled?serial port on the
pi.
sudo raspi-config
Option 5 - Turn on SSH and Serial interface, No for login shell of serial, Yes for enabling hardware
Finish
sudo reboot
It would also be good to post what the exact command is
you are trying to run.
Mat
On Fri, Dec 4, 2020 at
10:14 AM Mike - KB0FX <
mweilb@...> wrote:
I have a PI Teensy TNC
G8BPQ K2MJM v4 I am trying to get working with a Raspberry
Pi 3B+ . This board has a Teensy 3.6. I have been able to
use the firmware loader to install Pi9K Raspberry Pi
Firmware Tennsy36 0416202.hex. Once attached to the RPI I
am unable to communicate with the PI TNC via the serial
port using pitnc_getparms. Has anyone else worked with
this board?
Thanks
Mike -KB0FX
